Sheet Metal Layout and Pattern Development Flashcards

When using triangulation to develop a pattern for an oval-to-round fitting, what is the first step?

Answer: Divide both the oval and round openings into an equal number of spaces

The first step in triangulation is to divide both openings into an equal number of spaces. Lines are then drawn connecting corresponding points to create triangles whose true lengths can be determined.

What is the purpose of notching corners on a sheet metal pattern before folding?

Answer: To remove excess material that would overlap or interfere when the edges are bent

Notching removes material at corners so that when the pattern is folded, the edges meet cleanly without overlapping, bunching, or causing uneven seams.

What is the seam allowance typically added for a drive cleat connection?

Answer: 3/8 inch on each side

A drive cleat connection typically requires approximately 3/8 inch seam allowance on each edge where the cleat will be applied. This provides enough material to fold over and lock into the cleat.

What is the relationship between the slant height and the base radius when developing a right cone pattern?

Answer: The slant height becomes the radius of the arc in the flat pattern

When developing a right cone, the slant height of the cone becomes the radius used to draw the arc of the flat pattern. The arc length equals the circumference of the cone's base.

How many equal spaces is a circle typically divided into when developing a cylindrical pattern using parallel line development?

Answer: 12 spaces

A circle is typically divided into 12 equal spaces (every 30 degrees) for parallel line development. This provides sufficient accuracy for most sheet metal applications while keeping the layout manageable.

What does 'setback' refer to in sheet metal pattern layout?

Answer: The distance from the beginning of a bend to the point where the inside surfaces of the material would meet if extended

Setback is the distance from the start of a bend to the theoretical intersection point of the inside surfaces (the mold line). It is used to determine where bend lines fall on a flat pattern.