Sample Flashcards
6 cards from real Ramsay Test practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Sample flashcards as text
A technician measures the resistance of a motor winding and finds it reads 0 Ω. What does this most likely indicate?
Answer: A shorted winding
A reading of 0 Ω (or near zero) indicates a shorted winding — the coil conductors are making direct contact, bypassing the intended resistance. An open winding would read infinite (OL) resistance, not zero.
When using a megohmmeter (megger) to test insulation on a 480V motor, which minimum insulation resistance reading is generally considered acceptable before energizing?
Answer: 1 MΩ
Industry standard (IEEE 43) requires at least 1 MΩ of insulation resistance before energizing a motor. Readings below this threshold indicate compromised insulation that could lead to ground faults or equipment damage.
A three-phase induction motor is running but drawing unequal current on each phase. The supply voltages are balanced. What is the most likely cause?
Answer: Unbalanced or shorted stator windings
With balanced supply voltages, unequal phase currents point to an internal motor problem — specifically unbalanced or partially shorted stator windings, which alter the impedance on one or more phases. Mechanical overload would raise all phases proportionally.
A hydraulic system maintains pressure when the pump is off, but pressure drops slowly over several minutes with no visible external leaks. What is the most probable cause?
Answer: Internal bypass across the directional control valve
Slow pressure decay with no external leaks indicates internal leakage — most commonly across the spool of a directional control valve that is not sealing fully. Worn pump components would only matter while the pump runs, not after it stops.
On a ladder logic diagram, a normally-closed (NC) contact connected in series with a coil represents which condition during normal (non-faulted) operation?
Answer: The contact passes current when its reference bit is FALSE
An NC contact is closed (allows current) when its associated bit is FALSE (de-energized). It opens — interrupting the rung — when the bit is TRUE. This is the inverse logic of a normally-open contact.
A mechanic applies a dial indicator to check radial runout on a rotating shaft and reads 0.012 inches TIR (Total Indicator Reading). What does TIR represent in this measurement?
Answer: The difference between the maximum and minimum indicator readings over one full rotation
TIR (Total Indicator Reading) is the full swing of the dial indicator — from its lowest to its highest reading — over one complete revolution. It represents the total variation in surface position relative to the axis, which equals twice the eccentricity.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- ramsaycorp.com — Test delivery, fees, exam format, time limit, score validity · verified Oct 2026