Ramsay Test Print Reading and Schematics 5

Question 1

On an electrical schematic, a relay coil is labeled 'CR2' and its associated normally-open contact appears elsewhere on the drawing also labeled 'CR2'. The contact is shown with a dashed line connecting it back to the coil symbol. What does this dashed line convention most precisely indicate?

Accepted Answer

A cross-reference showing the coil and contact are part of the same control relay device

Answer

Dashed lines between a coil symbol and its remote contacts in ladder or schematic diagrams are cross-reference lines. They visually tie together all elements belonging to the same device (CR2) even when they appear on different rungs or pages, helping technicians trace the complete circuit without confusion. This is a standard IEC/NEMA drafting convention.

Question 2

A hydraulic circuit diagram shows a directional control valve symbol with a spring on one side and a solenoid on the other, with two distinct internal flow-path boxes. The center box shows all ports blocked. Which valve configuration does this represent?

Accepted Answer

4/3 solenoid-spring, closed-center

Answer

The symbol describes a 4-way (four ports), 3-position (three internal boxes) valve. The spring on one end and solenoid on the other indicate spring-return single-solenoid actuation. The center box with all ports blocked identifies it as a closed-center valve — in de-energized neutral, the pump is deadheaded and the actuator is locked. This is the 4/3 solenoid-spring, closed-center configuration.

Question 3

A mechanical drawing specifies a shaft diameter of Ø 1.500 with a geometric dimensioning and tolerancing (GD&T) feature control frame reading: ⌀0.005 M A B. What does the circled M symbol (Ⓜ) after the tolerance value mean in practical inspection terms?

Accepted Answer

Additional position tolerance is permitted as the feature departs from maximum material condition

Answer

The Ⓜ (Maximum Material Condition) modifier after the tolerance value means the stated tolerance (⌀0.005) applies when the feature is at its largest permissible size. As the actual shaft diameter decreases toward LMC, an equal amount of bonus tolerance is added. A shaft machined 0.002 under MMC would receive ⌀0.007 total position tolerance — this is the MMC bonus tolerance principle.

Question 4

In a ladder logic diagram, an input rung contains an XIC (Examine If Closed) instruction for input I:0/3 in series with an XIO (Examine If Open) instruction for the same address I:0/3. What is the logic state of this rung regardless of the physical input signal?

Accepted Answer

Always FALSE, because the two instructions create a logical contradiction on the same bit

Answer

XIC passes power when the bit is 1 (ON); XIO passes power when the bit is 0 (OFF). When both instructions reference the exact same address in series, only one can be satisfied at any given instant — they are logical complements. The series combination is equivalent to the Boolean expression A AND NOT(A), which is always FALSE. The rung can never go true, making it a logical dead rung.

Question 5

A pneumatic schematic shows a flow control valve symbol with an arrow drawn diagonally through a fixed restriction, and a check valve symbol in parallel with it. Flow enters from the actuator side. What is the precise function of this combined symbol?

Accepted Answer

Meter-out speed control: restricts exhaust flow leaving the cylinder while allowing free flow into it

Answer

The combination of a variable restriction in parallel with a check valve oriented to bypass the restriction in one direction is a unidirectional flow control. Since flow enters from the actuator (exhaust) side and the check valve allows free passage in that direction, the restriction only acts on flow leaving the actuator. This is meter-out control — it regulates the speed of the actuator by throttling its exhaust, which provides more stable speed control under varying loads than meter-in.

Ramsay Test Practice Test

Ramsay Test Practice Test

Ramsay Test Print Reading and Schematics 5