PC Plumber Tools & Equipment Handling 2

Question 1

What is the primary purpose of a pipe reamer after cutting pipe with a hacksaw?

Accepted Answer

To remove burrs and smooth the inside edge

Answer

To measure the pipe diameter

Answer

To apply flux to the pipe end

Answer

To test water pressure inside the pipe

Question 2

Which type of wrench is MOST appropriate for tightening large-diameter plastic PVC fittings?

Accepted Answer

Strap wrench

Answer

Chain wrench

Answer

Pipe wrench

Answer

Basin wrench

Question 3

A plumber's snake (hand auger) is being used to clear a clog. In which direction should the cable be rotated as it is fed into the drain?

Accepted Answer

Clockwise only

Answer

Counterclockwise only

Answer

Alternating directions every 6 inches

Answer

Direction does not matter

Question 4

When using a propane torch to sweat copper fittings, flux should be applied:

Accepted Answer

To both the pipe end and the inside of the fitting before assembly

Answer

After heating the fitting to soldering temperature

Answer

Only to the outside of the fitting hub

Answer

Only to the pipe end, never the fitting

Question 5

Which tool is used to cut threads on the outside of a steel pipe?

Accepted Answer

Die

Answer

Tap

Answer

Reamer

Answer

Deburring tool

Question 6

What is the correct technique for using a basin wrench to tighten a faucet mounting nut?

Accepted Answer

Extend the handle into the cabinet and rotate with a long swing

Answer

Attach it to the supply line and pull down

Answer

Use it only from above the sink deck

Answer

Grip the nut with the fixed jaw and pull toward you

Question 7

A 4-in-1 screwdriver is an example of which tool category?

Accepted Answer

Combination/multi-use hand tool

Answer

Power tool

Answer

Specialty diagnostic tool

Answer

Percussion tool