Master Plumber Drainage, Waste, and Venting Questions and Answers

Question 1

A master plumber is designing a DWV system for a multi-story building. A soil stack has a horizontal offset greater than 45 degrees. According to most model codes, how must the portion of the stack BELOW the offset be sized?

Accepted Answer

Based on the total number of drainage fixture units on the entire stack or the size of the offset, whichever is larger.

Answer

When a soil or waste stack has an offset greater than 45 degrees, it creates a significant disruption in flow. The portion of the stack below this offset must be sized to handle the potential for hydraulic jump and increased pressure. Therefore, codes require it to be sized based on the larger of two values: the size required for the offset itself (which is sized as a building drain) or the size required for the total drainage fixture unit load of the entire stack.

Question 2

When performing a water test on a newly installed plastic DWV system, what is the minimum required head of water that must be applied above the highest point of the system being tested, and for what duration, according to the 2021 IPC?

Accepted Answer

10 feet of head for 15 minutes

Answer

The 2021 International Plumbing Code (IPC) mandates that a water test on a DWV system must be conducted by filling the system with water to a point that creates at least a 10-foot head of pressure on all parts of the system being tested. This pressure must be maintained for a minimum of 15 minutes to ensure there are no leaks. This requirement was reverted from a 5-foot head in previous editions to align with the air test pressure and provide a more thorough test.

Question 3

A plumber is installing an island sink and must use an island fixture vent (loop vent). Which of the following is a mandatory requirement for this type of installation under the Uniform Plumbing Code (UPC)?

Accepted Answer

A 'foot vent' must be taken off the vertical fixture vent immediately below the floor.

Answer

The UPC has specific and detailed requirements for island fixture venting. A key component is the 'foot vent.' This vent connects to the vertical portion of the fixture vent just below the floor level and extends to a nearby partition where it can connect to the main vent system or terminate to the open air. This ensures proper air circulation and prevents siphoning of the trap. The return bend also has specific fitting requirements, typically an assembly of 45, 90, and 45-degree elbows.

Question 4

In which of the following scenarios is a Combination Waste and Vent System most likely to be permitted by the authority having jurisdiction?

Accepted Answer

For floor drains in a large, open-plan grocery store where running conventional vents is structurally impractical.

Answer

Combination waste and vent systems are specialized systems permitted only in limited circumstances, typically where structural conditions make conventional venting impossible or impractical. They are suitable for fixtures like floor drains or sinks in large open areas, like a commercial food preparation area or grocery store, where there are no nearby walls to run vent pipes. They are generally not permitted for fixtures that receive heavy solid waste (like water closets) or suds-producing waste.

Question 5

According to the IPC, what is the minimum diameter for any soil or waste stack that receives the discharge from a water closet?

Accepted Answer

3 inches

Answer

To ensure proper transport of solid waste and prevent blockages, model plumbing codes establish a minimum stack size for fixtures discharging significant solids. The International Plumbing Code (IPC) specifies that no water closet shall discharge into a stack less than 3 inches in diameter. While a 4-inch stack is common practice, 3-inch is the minimum code requirement in many residential applications.

Master Plumber Exam Practice Test

Master Plumber Exam Practice Test

Master Plumber Drainage, Waste, and Venting Questions and Answers