FREE MRSO Radiofrequency (RF) Field Bioeffects and Specific Absorption Rate (SAR) Questions and Answers

Question 1

Specific Absorption Rate (SAR) is a measure of the:

Accepted Answer

Rate of RF energy absorption per unit mass of tissue.

Answer

SAR is the primary metric used to quantify the patient's exposure to RF energy. It is defined as the rate at which RF energy is absorbed by the body per unit of mass and is measured in watts per kilogram (W/kg).

Question 2

Under the FDA's guidelines for Normal Operating Mode, what is the whole-body average SAR limit averaged over 6 minutes?

Accepted Answer

2.0 W/kg

Answer

For Normal Operating Mode, which requires no special monitoring, the FDA sets the whole-body average SAR limit at 2.0 W/kg. This limit is designed to ensure that the RF energy deposited does not raise the body's core temperature by more than a safe amount.

Question 3

How does SAR deposition change when the static magnetic field strength (B0) is doubled (e.g., from 1.5T to 3.0T), assuming all other sequence parameters are kept the same?

Accepted Answer

It is quadrupled.

Answer

SAR is proportional to the square of the Larmor frequency, and the Larmor frequency is directly proportional to the B0 field strength. Therefore, doubling the B0 field strength (e.g., from 1.5T to 3.0T) results in a four-fold (quadrupled) increase in SAR, as SAR is proportional to B0 squared.

Question 4

Scanning in the First Level Controlled Operating Mode requires which of the following?

Accepted Answer

Continuous monitoring and medical supervision.

Answer

First Level Controlled Operating Mode allows for SAR levels that may produce significant physiological stress. Therefore, it requires explicit confirmation from the MRSO or a designated delegate, continuous verbal and visual contact with the patient, and monitoring of vital signs as deemed appropriate by medical staff.

Question 5

What is the most common cause of serious RF-related thermal injuries (burns) to patients in the MRI environment?

Accepted Answer

Formation of a conductive loop by skin contact or cables.

Answer

The most frequent cause of RF burns is the formation of a conductive loop. This can occur when a patient's skin touches the bore of the magnet (skin-to-bore), when two skin surfaces touch (e.g., thigh-to-thigh), or when ECG cables or other conductive wires form a loop on the patient, allowing RF energy to concentrate and cause severe heating.

MRSO - Magnetic Resonance Safety Officer Practice Test

MRSO - Magnetic Resonance Safety Officer Practice Test

FREE MRSO Radiofrequency (RF) Field Bioeffects and Specific Absorption Rate (SAR) Questions and Answers