CSWA - Certified Solidworks Associate Dimensions and Annotations Questions and Answers

Question 1

When sketching, a designer adds a dimension that conflicts with existing dimensions and relations. What is this state called, and how does SOLIDWORKS typically indicate it?

Accepted Answer

Over-defined, indicated by yellow or red-colored dimensions/relations.

Answer

When a dimension or relation is redundant or conflicts with others, the sketch is over-defined. SOLIDWORKS signals this with yellow or red colors to prompt the user to resolve the conflict.

Question 2

Which of the following best describes a 'driven' or 'reference' dimension in a SOLIDWORKS sketch?

Accepted Answer

A read-only dimension that reports a measurement but does not control the sketch geometry.

Answer

A driven (or reference) dimension is for measurement purposes only. It is shown in gray and often in parentheses by default and will update if the geometry changes, but it cannot be edited to drive the geometry. This prevents over-defining the sketch.

Question 3

A designer has created a part using the Hole Wizard to create several counterbore holes. When creating the manufacturing drawing, what is the most efficient and standardized method to add detailed specifications for these holes?

Accepted Answer

Use the Hole Callout tool on the Annotation toolbar.

Answer

The Hole Callout tool is specifically designed to read the information from a Hole Wizard feature and automatically generate a standardized, detailed note that includes diameter, depth, counterbore/countersink details, and instance counts.

Question 4

In a SOLIDWORKS sketch, what does the color black signify for sketch entities like lines and arcs?

Accepted Answer

The entities are fully defined by dimensions and/or geometric relations.

Answer

Black indicates that a sketch entity is fully defined. Its position and size are locked by a combination of dimensions and relations relative to the origin or other defined geometry. Blue indicates it is under-defined.

Question 5

A designer receives a part file modeled in inches. The drawing requirements specify that all dimensions must be displayed in millimeters with a precision of three decimal places. Where would the designer primarily make this change for the entire document?

Accepted Answer

In the Document Properties > Units settings.

Answer

Document-wide settings for the primary unit system (like changing from IPS to MMGS) and default precision for dimensions are controlled under Tools > Options > Document Properties > Units.

CSWA - Certified Solidworks Associate Practice Test

CSWA - Certified Solidworks Associate Practice Test

CSWA - Certified Solidworks Associate Dimensions and Annotations Questions and Answers