CER - Certified Endoscope Reprocessor High-Level Disinfection Processes Questions and Answers

Question 1

A reprocessor is preparing a reusable high-level disinfectant (HLD) solution, such as glutaraldehyde, for use. According to best practices, what must be done before immersing the first endoscope of the day?

Accepted Answer

Test the solution for its minimum effective concentration (MEC) using a product-specific test strip.

Answer

Before each use, reusable HLD solutions must be tested with a product-specific test strip to ensure the active ingredient is at or above the minimum effective concentration (MEC). This quality control step verifies that the solution is still capable of achieving high-level disinfection. The reuse life (e.g., 14 or 28 days) is also tracked, and the solution is discarded when the MEC fails or the reuse life expires, whichever comes first.

Question 2

During a manual high-level disinfection process using ortho-phthalaldehyde (OPA), which of the following represents a critical parameter that must be strictly followed according to the manufacturer's instructions for use (IFU)?

Accepted Answer

A 12-minute soak time at 20°C (68°F).

Answer

The effectiveness of high-level disinfectants like OPA is dependent on specific parameters of time and temperature. A common FDA-cleared contact condition for OPA is a 12-minute soak time at a minimum of 20°C (68°F) for manual reprocessing. Deviating from these validated parameters can lead to disinfection failure.

Question 3

A facility's automated endoscope reprocessor (AER) completes a high-level disinfection cycle. Which of the following is the most critical next step to prevent recontamination of the endoscope before storage?

Accepted Answer

Thorough rinsing with sterile or filtered water, followed by an alcohol flush and forced air drying.

Answer

After HLD, endoscopes must be thoroughly rinsed with sterile or bacteria-free water (e.g., passed through a 0.2-micron filter) to remove toxic disinfectant residue. This is followed by flushing channels with 70% alcohol to aid in drying and then purging all channels with forced, filtered air until visibly dry. Inadequate rinsing can cause patient injury, and inadequate drying can allow remaining waterborne microorganisms to proliferate.

Question 4

When selecting a high-level disinfectant for endoscope reprocessing, which characteristic of Peracetic Acid is a notable advantage?

Accepted Answer

It lacks toxic aldehyde vapors and has environmentally friendly byproducts (acetic acid and oxygen).

Answer

Peracetic acid is a strong oxidizing agent that is effective as a high-level disinfectant. A key advantage is that it breaks down into harmless byproducts: acetic acid (vinegar) and oxygen, making it more environmentally friendly and reducing toxic vapor concerns compared to aldehyde-based disinfectants. However, it can be corrosive to some metals like brass and copper.

Question 5

A reprocessing technician is documenting the manual HLD process for a colonoscope. Which of the following data points is LEAST critical to record in the reprocessing log?

Accepted Answer

The name of the patient the endoscope was previously used on.

Answer

While patient information is crucial for tracking in case of an exposure event, the name of the *previous* patient is not a critical parameter of the HLD process itself that needs to be logged for process quality control. The essential HLD process records include the lot number of the HLD, the MEC test result, the soak time and temperature, and the identifier of the endoscope being reprocessed to ensure traceability and confirm that all critical parameters were met.

CER - Certified Endoscope Reprocessor Practice Test

CER - Certified Endoscope Reprocessor Practice Test

CER - Certified Endoscope Reprocessor High-Level Disinfection Processes Questions and Answers