BCBA - Board Certified Behavior Analyst Measurement and Data Interpretation Questions and Answers

Question 1

A behavior analyst is monitoring the on-task behavior of a student during a 30-minute independent work period. The analyst decides to record whether the student is engaged in the assigned task for the entire 2-minute interval. Which discontinuous measurement procedure is being used?

Accepted Answer

Whole Interval Recording

Answer

Whole Interval Recording is the correct procedure because the observer records an occurrence only if the target behavior happens throughout the entire duration of the interval. In this scenario, the student must be on-task for the full 2 minutes for it to be counted. Partial interval recording would mark an occurrence if the behavior happened at any point, and momentary time sampling would only record the behavior if it was occurring at the very end of the interval. Latency recording is a continuous measurement of time, not an interval-based system.

Question 2

When visually analyzing a line graph of behavior data, what does 'level' refer to?

Accepted Answer

The value on the vertical axis around which a set of behavioral measures converge.

Answer

Level refers to the value on the vertical axis (y-axis) around which the data points tend to converge. It essentially represents the average magnitude or rate of the behavior during a specific condition or phase. 'Variability' describes the fluctuation of data points, and 'trend' refers to the overall direction of the data path. The point of intervention is marked by a phase change line, not the level.

Question 3

A BCBA is calculating interobserver agreement (IOA) for frequency data collected on a client's manding behavior. Observer A recorded 8 mands, and Observer B recorded 10 mands during the same observation period. Using the total count IOA formula, what is the IOA percentage?

Accepted Answer

80%

Answer

The formula for Total Count IOA is (Smaller Count / Larger Count) * 100. In this scenario, the smaller count is 8 and the larger count is 10. Therefore, the calculation is (8 / 10) * 100, which equals 80%.

Question 4

Which of the following is a primary advantage of using a continuous measurement procedure over a discontinuous measurement procedure?

Accepted Answer

It provides a complete and accurate record of every instance of the target behavior.

Answer

Continuous measurement, such as frequency or duration recording, captures every single instance of a behavior during the observation period. This provides a more complete and accurate representation of the behavior compared to discontinuous methods (e.g., interval recording, time sampling), which only capture a sample and can either overestimate or underestimate the true occurrence of the behavior.

Question 5

A behavior analyst is reviewing a client's data for self-injurious behavior (SIB) following the implementation of a new intervention. During baseline, the rate of SIB was high and stable. After the intervention, the data path shows a clear and immediate downward direction. This change in the data path BEST describes a change in:

Accepted Answer

Trend

Answer

Trend refers to the overall direction of the data path. A downward direction indicates a decreasing trend, which is the desired outcome for a deceleration target like SIB. While the level (average rate) also changed, the most accurate description of the 'direction' of the data path is its trend. Variability refers to the consistency of the data points, and reliability relates to the consistency of the measurement system itself.

BCBA - Board Certified Behavior Analyst Practice Test

BCBA - Board Certified Behavior Analyst Practice Test

BCBA - Board Certified Behavior Analyst Measurement and Data Interpretation Questions and Answers