OSHA OSHA - Safety Certificate Walking and Working Surfaces Questions and Answers 2 — Questions and Answers
Question 1: At what height must an employer provide fall protection for workers on walking-working surfaces with unprotected sides or edges?
- 4 feet (Correct answer)
- 6 feet
- 8 feet
- 10 feet
Correct answer: 4 feet
OSHA requires fall protection at 4 feet in general industry under 29 CFR 1910.28.
Question 2: What is the minimum width requirement for a general industry walkway according to OSHA standards?
- 22 inches
- 28 inches (Correct answer)
- 36 inches
- 44 inches
Correct answer: 28 inches
OSHA requires aisles and walkways to be at least 28 inches wide per 29 CFR 1910.22.
Question 3: How often must employers inspect walking-working surfaces to ensure they are maintained in a safe condition?
- As needed and with enough frequency to ensure safety (Correct answer)
- Weekly
- Monthly
- Annually
Correct answer: As needed and with enough frequency to ensure safety
OSHA requires inspections as needed and frequently enough to maintain safe conditions under 29 CFR 1910.22.
Question 4: Which of the following is a required characteristic of floor surfaces in work areas under OSHA regulations?
- They must be kept clean, orderly, and in a sanitary condition (Correct answer)
- They must be carpeted
- They must be painted with reflective coating
- They must be made of non-porous material
Correct answer: They must be kept clean, orderly, and in a sanitary condition
OSHA mandates that all places of employment be kept clean, orderly, and sanitary per 29 CFR 1910.22(a).
Question 5: What must an employer do when a hole in a walking-working surface cannot be immediately repaired?
- Mark the area with caution tape only
- Cover the hole or guard it with a railing to prevent falls (Correct answer)
- Redirect foot traffic to another building
- Close the entire floor to all personnel
Correct answer: Cover the hole or guard it with a railing to prevent falls
OSHA requires that holes be covered or guarded to prevent workers from stepping into or falling through them.
Question 6: Under OSHA's walking-working surfaces standard, what is the maximum load rating information that must be marked on a floor or roof opening cover?
- The cover must be able to support the maximum intended load (Correct answer)
- The cover must support at least 100 pounds
- The cover must support twice the weight of the heaviest employee
- The cover must support at least 500 pounds
Correct answer: The cover must be able to support the maximum intended load
Covers must be capable of supporting the maximum intended load that may be imposed on them per 29 CFR 1910.29.
OSHA OSHA - Safety Certificate Walking and Working Surfaces Questions and Answers 2
At what height must an employer provide fall protection for workers on walking-working surfaces with unprotected sides or edges?