Practice Test Geeks(NCCER Crane) National Center for Construction Education and Research Crane Certification Practice Test
← All NCCER CRANE Flashcard Decks

Crane Regulations & Standards (OSHA 1926 Subpart CC / ASME B30.5) Flashcards

6 cards from real NCCER CRANE practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 Crane Regulations & Standards (OSHA 1926 Subpart CC / ASME B30.5) flashcards as text

  1. Which OSHA regulation covers cranes and derricks used in construction?

    Answer: 29 CFR 1926 Subpart CC

    29 CFR 1926 Subpart CC (1926.1400–1926.1442) is OSHA's construction standard for cranes and derricks. Subpart N of 1910 covers general industry, Subpart M covers fall protection, and 1904 covers injury recordkeeping.

  2. Which ASME consensus standard applies specifically to mobile and locomotive cranes?

    Answer: ASME B30.5

    ASME B30.5 covers mobile and locomotive cranes. B30.9 covers slings, B30.3 covers tower cranes, and B30.26 covers rigging hardware.

  3. Under OSHA 1926.1427, what is the maximum period an operator certification is valid before recertification?

    Answer: 5 years

    OSHA 1926.1427 limits an operator certification to a maximum of 5 years. After that, the operator must recertify.

  4. Under Subpart CC, who must perform the inspection of a crane at the start of each shift?

    Answer: A competent person

    OSHA 1926.1412 requires a competent person to perform a visual shift inspection before or during each shift. Annual or comprehensive inspections require a qualified person.

  5. If the voltage of a nearby power line is unknown, what minimum clearance does OSHA require between the line and any part of the crane, load or load line?

    Answer: 20 feet

    Under 1926.1408, when the voltage is unknown or the employer uses Option 1, the minimum clearance is 20 feet. The utility must confirm the voltage before Table A distances can be used.

  6. During crane assembly or disassembly, who must OSHA 1926.1404 place in charge of the work?

    Answer: An A/D director who is both competent and qualified

    OSHA requires assembly and disassembly to be directed by an A/D director who meets the criteria for both a competent person and a qualified person, or who is a competent person assisted by a qualified person.

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. nccer.org — Exam format, passing score, score release, time limit, eligibility, renewal, retake policy, score validity, test delivery, exam information · verified Oct 2026