Practice Test GeeksNCCCO (National Commission for the Certification of Crane Operators) Practice Test
← All NCCCO Flashcard Decks

OSHA Crane Regulations 29 CFR 1926 Flashcards

7 cards from real NCCCO practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 OSHA Crane Regulations 29 CFR 1926 flashcards as text

  1. Under 29 CFR 1926.1416, how frequently must a qualified person perform a comprehensive inspection of the crane?

    Answer: Annually or as specified by the manufacturer

    29 CFR 1926.1416(d) requires a qualified person to perform comprehensive inspections at intervals specified by the manufacturer or, if not specified, at least annually.

  2. According to 29 CFR 1926.1411, what is the minimum distance crane equipment must maintain from an overhead power line rated at 50 kV or less when operating under Table A conditions?

    Answer: 10 feet

    Table A of 29 CFR 1926.1408 establishes a minimum 10-foot clearance for power lines up to 50 kV unless the line is de-energized or a qualified electrical engineer determines otherwise.

  3. Under 29 CFR 1926.1425, when must a tag line be used during a lifting operation?

    Answer: When the load must be controlled to prevent unintentional contact with persons or objects

    Tag lines are required under 1926.1425 when they are necessary to prevent the load from unintentionally contacting persons or structures.

  4. 29 CFR 1926.1402 requires ground conditions to be assessed before crane operations. Who is responsible for ensuring the ground can support the crane?

    Answer: The employer

    Under 1926.1402, the employer is responsible for ensuring that ground conditions are adequate to support the crane, load, and associated equipment.

  5. According to 29 CFR 1926.1417, an operator must stop crane operations if a safety device is discovered to be malfunctioning. Which of the following BEST describes when work may resume?

    Answer: After the defect is corrected and the device is operational

    1926.1417(c) states that a crane with a safety device malfunction must be taken out of service until the defect is corrected.

  6. Under 29 CFR 1926.1404, what document or information must be available to the operator at the crane controls during operation?

    Answer: Load charts and relevant manufacturer procedures

    1926.1404(h) requires that the applicable load chart and relevant manufacturer procedures be available to the operator at the controls.

  7. When a crane is used in Assembly/Disassembly (A/D) operations, 29 CFR 1926.1403 requires a qualified person to do which of the following?

    Answer: Supervise all A/D work and make a determination that it is being done in accordance with manufacturer procedures

    1926.1403 requires a qualified person to supervise A/D operations and determine that work conforms to manufacturer procedures and applicable regulations.