Music & Audio Advice Microphone Types and Techniques Questions and Answers 1

Question 1

An audio engineer is setting up to record a solo vocalist in a studio. They want a warm, full-bodied vocal tone and plan to use the proximity effect to their advantage. Which microphone polar pattern would be unsuitable for achieving this specific goal?

Accepted Answer

Omnidirectional

Answer

The proximity effect, an increase in low-frequency response as a source gets closer to a microphone, only occurs in directional microphones (like cardioid, hypercardioid, and figure-8) that operate on a pressure-gradient principle. Omnidirectional microphones are pressure-operated, meaning they sense sound pressure at a single point and are not susceptible to the proximity effect.

Question 2

A recording engineer is using a high-quality condenser microphone to capture the detailed nuances of an acoustic guitar. The microphone is connected to a mixing console, but no sound is being registered. All cables are confirmed to be working. What is the most likely cause of the issue?

Accepted Answer

Phantom power is not engaged.

Answer

Condenser microphones contain active electronics and require an external power source to charge the capacitor (diaphragm and backplate) and power the internal preamplifier. This power, typically +48V DC, is sent through the XLR cable and is known as phantom power. Without it, a condenser microphone cannot produce a signal.

Question 3

Which of the following stereo miking techniques involves a directional (mid) microphone pointed at the source and a bi-directional (side) microphone aimed left and right, requiring a matrix decoder (or specific DAW routing) to create the stereo image?

Accepted Answer

Mid-Side (M-S)

Answer

The Mid-Side (M-S) technique uses a cardioid microphone (Mid) facing the source and a figure-8 microphone (Side) positioned at a 90-degree angle to capture ambient and directional information. The signals from these two microphones are then processed through a matrix (by duplicating the side channel, inverting its phase, and panning the two side channels hard left and right) to generate a variable-width stereo image.

Question 4

A sound engineer needs to record a live rock band. The priority is capturing the loud, high-SPL (Sound Pressure Level) guitar amplifiers and snare drum without distortion, while also ensuring the microphones can withstand the rigors of a live stage environment. Which microphone type is best suited for this application?

Accepted Answer

Dynamic

Answer

Dynamic microphones are known for their durability and ability to handle very high sound pressure levels without distorting. Their less sensitive nature and robust construction make them the industry standard for miking loud sources like guitar cabinets, drums, and for use in demanding live sound environments.

Question 5

When setting up a Blumlein Pair for a stereo recording, which specific type of microphone and polar pattern configuration is required?

Accepted Answer

Two co-incident bi-directional (figure-8) microphones angled at 90 degrees.

Answer

The Blumlein Pair technique specifically requires two bi-directional (figure-8) microphones placed at the same point (coincident) and angled 90 degrees apart. This setup captures a highly realistic stereo image along with natural room ambiance from the rear lobes of the microphones.

Music & Audio Advice Practice Test

Music & Audio Advice Practice Test

Music & Audio Advice Microphone Types and Techniques Questions and Answers 1