← All MPharm Master of Pharmacy Flashcard Decks

Master of Pharmacy: Pharmaceutical Formulations and Dosage Forms Flashcards

7 cards from real MPharm Master of Pharmacy practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Master of Pharmacy: Pharmaceutical Formulations and Dosage Forms flashcards as text
  1. Which inhalation device generates particles through vibration of a liquid droplet mesh or membrane, requiring no propellant?

    Answer: Soft mist inhaler (SMI) / vibrating mesh nebulizer

    Vibrating mesh nebulizers use a piezoelectric-driven mesh with thousands of apertures to produce a fine aerosol without propellants or compressed air.

  2. For ophthalmic solutions, which tonicity value (mOsmol/kg) is considered isotonic with lacrimal fluid?

    Answer: 308 mOsmol/kg

    Lacrimal fluid is isotonic at approximately 308 mOsmol/kg (equivalent to 0.9% NaCl), and ophthalmic formulations are adjusted to this tonicity to minimize irritation.

  3. In freeze-drying (lyophilization), the primary drying stage removes water by:

    Answer: Sublimation of ice under vacuum below the product's collapse temperature

    Primary drying sublimates frozen water directly to vapor under low pressure, bypassing the liquid phase, while maintaining the product below its collapse temperature.

  4. Which parameter describes the fraction of a drug dose absorbed from a solid oral dosage form relative to an IV dose?

    Answer: Absolute bioavailability (F)

    Absolute bioavailability (F) is calculated as (AUC_oral/AUC_IV) × (Dose_IV/Dose_oral), reflecting the fraction of drug that reaches systemic circulation.

  5. Capping and lamination defects during tablet compression are most often caused by:

    Answer: Air entrapment in the die and excessive compression speed or elastic recovery

    Capping occurs when entrapped air or high elastic recovery causes the top or bottom cap to separate from the tablet body after ejection.

  6. Enteric coatings are designed to remain intact in the stomach (pH ~1–2) and dissolve in the small intestine (pH ~5.5–7.5). Which polymer achieves this?

    Answer: Cellulose acetate phthalate (CAP) / Eudragit L

    Cellulose acetate phthalate and Eudragit L contain carboxylic acid groups that ionize and dissolve above pH 5.5, protecting the stomach while releasing drug intestinally.

  7. The Biopharmaceutics Classification System (BCS) categorizes a drug with high solubility and low permeability as:

    Answer: BCS Class III

    BCS Class III drugs dissolve readily but are poorly absorbed due to limited membrane permeability, making permeation enhancement strategies relevant.