MHC Safety Procedures & Regulations 2

Question 1

Under OSHA 29 CFR 1910.178, what is the maximum safe load capacity a forklift operator must observe?

Accepted Answer

The capacity listed on the manufacturer's data plate

Answer

OSHA requires operators to follow the rated capacity shown on the forklift's data plate and never exceed it.

Question 2

When must a pre-operational inspection of material handling equipment be performed?

Accepted Answer

At the beginning of each shift before use

Answer

OSHA mandates a pre-shift inspection before each use to identify defects that could create hazards.

Question 3

What action should a worker take if a conveyor's emergency stop cord is pulled and the hazard is cleared?

Accepted Answer

Notify a supervisor and reset only after confirming the line is clear

Answer

After an e-stop, the conveyor must be confirmed clear of people and hazards before an authorized reset.

Question 4

Which personal protective equipment (PPE) is most commonly required in areas where overhead loads are moved by crane or hoist?

Accepted Answer

Hard hat and steel-toed boots

Answer

Overhead material handling creates falling-object hazards, making hard hats and steel-toed boots the standard PPE requirement.

Question 5

A pallet rack is found with a bent upright after a forklift impact. What is the correct immediate action?

Accepted Answer

Unload, tag out, and remove from service until repaired

Answer

Damaged rack uprights compromise structural integrity and must be taken out of service immediately until professionally repaired or replaced.

(MHC) Material Handling Certification Practice Test