MHC Material Handling Equipment Operation 3

Question 1

An order selector (order picker) operator must wear a fall arrest harness because:

Accepted Answer

The operator platform elevates with the forks, creating fall risk

Answer

Order picker operators ride the elevated platform and are exposed to fall hazards, requiring a full-body harness attached to the anchor point on the machine.

Question 2

What is the primary purpose of anti-slip plates or cross-hatching on forklift fork surfaces?

Accepted Answer

To increase friction and prevent loads from sliding off the forks

Answer

Anti-slip texturing on forks increases friction between the load and fork surface, helping prevent loads from sliding during travel.

Question 3

During a pre-operation inspection, an operator finds the forklift's horn is not working. The operator should:

Accepted Answer

Tag the unit out of service and report it before operating

Answer

A non-functional horn is a safety defect; the operator must tag the unit out of service and notify a supervisor before operation.

Question 4

When using a walkie stacker to stack pallets, the operator must ensure the stacking surface is:

Accepted Answer

Level, firm, and capable of supporting the combined load weight

Answer

The stacking surface must be level, stable, and have adequate floor load capacity to safely support stacked pallets and the equipment.

Question 5

A double-reach truck differs from a standard reach truck because it:

Accepted Answer

Can extend its forks two pallet positions deep into racking

Answer

A double-deep reach truck has extended pantograph arms that allow it to place or retrieve pallets two positions deep in double-deep racking systems.

(MHC) Material Handling Certification Practice Test

(MHC) Material Handling Certification Practice Test

MHC Material Handling Equipment Operation 3