MHC Material Handling Equipment Operation 2

Question 1

When operating a powered industrial truck on a loading dock, what is the primary hazard to watch for?

Accepted Answer

Dock leveler gaps and edge drop-offs

Answer

Dock edges and leveler gaps present the most critical fall hazard for powered industrial trucks operating on loading docks.

Question 2

What does the rated capacity of a forklift assume about the load's center of gravity?

Accepted Answer

Located at 24 inches from the front face of the forks

Answer

OSHA standards assume the load center of gravity is at 24 inches from the front face of the forks when rating forklift capacity.

Question 3

A reach truck operator is picking a pallet from a high rack. At what point should the operator stop raising the forks?

Accepted Answer

When the forks are slightly above the pallet entry height

Answer

Forks should be raised only enough to clear the pallet entry height to prevent striking rack beams or overhead obstructions.

Question 4

Which condition requires an operator to immediately remove a counterbalanced forklift from service?

Accepted Answer

A cracked or bent fork arm

Answer

Cracked or bent forks are a critical safety defect that makes the forklift unsafe to operate and requires immediate removal from service.

Question 5

When traveling with a loaded pallet jack on a downhill ramp, the operator should:

Accepted Answer

Walk behind the load so it leads down the ramp

Answer

On downhill grades, the load should lead so it acts as a buffer and the operator remains uphill of the load to maintain control.

(MHC) Material Handling Certification Practice Test