MASS Technical Reading Comprehension 2

Question 1

A maintenance manual states: "Disconnect the power supply before removing the access panel." What must be done first?

Accepted Answer

Disconnect the power supply

Answer

The instruction specifies disconnecting power before any panel removal.

Question 2

A safety data sheet reads: "In case of skin contact, rinse immediately with plenty of water for at least 15 minutes." What is the minimum rinse time?

Accepted Answer

15 minutes

Answer

The sheet states a minimum of 15 minutes of rinsing.

Question 3

A procedure says: "Tighten all bolts to 25 Nm, then re-check after the engine has cooled." When should bolts be re-checked?

Accepted Answer

After the engine has cooled

Answer

Re-checking occurs after the engine has cooled, per the instruction.

Question 4

A label warns: "Do not exceed a load of 500 kg." A 520 kg load is placed on the equipment. This action is:

Accepted Answer

Over the limit

Answer

520 kg exceeds the stated 500 kg maximum.

Question 5

A diagram caption states: "Valve A controls coolant flow; Valve B controls fuel flow." To stop coolant, which valve is used?

Accepted Answer

Valve A

Answer

Valve A controls coolant flow.

MASS Test Practice Test