KDOT Safety Regulations & Compliance 3

Question 1

A KDOT inspector observes a concrete pump truck being operated within 10 feet of an overhead power line rated at 50 kV. What OSHA clearance is required?

Accepted Answer

20 feet

Answer

OSHA 29 CFR 1926.1408 requires a minimum 20-foot clearance for power lines rated above 50 kV up to 200 kV.

Question 2

Which KDOT document outlines the specific safety requirements that contractors must follow on state highway projects in Kansas?

Accepted Answer

KDOT Standard Specifications for State Road & Bridge Construction

Answer

The KDOT Standard Specifications for State Road & Bridge Construction contains the contractually binding safety requirements for all KDOT projects.

Question 3

What action must a KDOT inspector take if a contractor's safety plan does not address a newly identified site hazard?

Accepted Answer

Direct the contractor to update the safety plan before work in the hazard area resumes

Answer

The inspector must direct the contractor to update their safety plan to address the identified hazard before permitting work to resume in that area.

Question 4

Under MUTCD standards adopted by KDOT, what is the minimum retroreflectivity rating required for orange construction zone signs on high-speed roadways?

Accepted Answer

Type III sheeting (high intensity)

Answer

KDOT requires at minimum Type III high-intensity retroreflective sheeting on temporary traffic control signs for high-speed work zones.

Question 5

According to KDOT requirements, how soon must a contractor report a work-related fatality to KDOT's project engineer?

Accepted Answer

Immediately (as soon as practicable)

Answer

Fatalities must be reported to the KDOT project engineer immediately, while the parallel OSHA 8-hour fatality reporting requirement also applies.

(KDOT) Certified Kansas Department of Transportation Inspector Practice Test

(KDOT) Certified Kansas Department of Transportation Inspector Practice Test

KDOT Safety Regulations & Compliance 3