← All IKM Flashcard Decks

Networking Flashcards

20 cards from real IKM practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 20 Networking flashcards as text
  1. What is the standard Ethernet MTU size?

    Answer: 1500 bytes

    The standard Ethernet MTU is 1500 bytes, the maximum payload size of an Ethernet frame.

  2. Which routing protocol uses the Dijkstra algorithm?

    Answer: OSPF

    OSPF is a link-state routing protocol that uses Dijkstra's shortest path first algorithm.

  3. What is the purpose of the ARP protocol?

    Answer: Map IP addresses to MAC addresses

    ARP resolves IPv4 addresses to MAC addresses on a local network segment.

  4. Which topology provides highest fault tolerance but requires the most cabling?

    Answer: Full mesh

    A full mesh topology connects every device directly to every other device.

  5. What is the primary difference between a hub and a switch?

    Answer: Switches forward frames by MAC address while hubs broadcast to all ports

    Switches maintain a MAC address table and forward frames only to the correct port, while hubs broadcast to every port.

  6. Which port number is used by DNS?

    Answer: 53

    DNS uses port 53 for both UDP (standard queries) and TCP (zone transfers).

  7. How many usable host addresses does a /27 IPv4 subnet provide?

    Answer: 30

    A /27 leaves 5 host bits (2^5 = 32), minus the network and broadcast addresses gives 30 usable hosts.

  8. On an IPv4 LAN, which protocol finds the MAC address for a known IP address?

    Answer: ARP

    ARP broadcasts a request for an IPv4 address and the owner replies with its MAC address.

  9. What is the correct order of the DHCP lease exchange between a new client and a server?

    Answer: Discover, Offer, Request, Acknowledge

    DHCP follows the DORA sequence: Discover, Offer, Request, Acknowledge.

  10. In Spanning Tree Protocol, how is the root bridge elected?

    Answer: The switch with the lowest bridge ID (priority plus MAC address)

    STP picks the lowest bridge ID; if priorities are equal, the lowest MAC address breaks the tie.

  11. What is the default Cisco administrative distance for routes learned through OSPF?

    Answer: 110

    OSPF has a default administrative distance of 110, versus 90 for internal EIGRP and 120 for RIP.

  12. Which DNS record type maps a hostname to an IPv6 address?

    Answer: AAAA

    AAAA records hold 128-bit IPv6 addresses; A records hold IPv4 addresses.

  13. Which side of a TCP connection enters the TIME_WAIT state?

    Answer: The side that sends the first FIN (active close)

    The active closer stays in TIME_WAIT for 2×MSL so that delayed segments expire and its final ACK can be resent if needed.

  14. IPv4 Path MTU Discovery depends on which ICMP message being delivered back to the sender?

    Answer: Destination Unreachable – Fragmentation Needed and DF Set (Type 3, Code 4)

    Routers send Type 3 Code 4 when a packet with the DF bit set is too large, so firewalls that block it break PMTUD.

  15. Which prefix is reserved for IPv6 link-local unicast addresses?

    Answer: fe80::/10

    Link-local addresses use fe80::/10 and are never routed beyond the local link.

  16. How many bytes does an IEEE 802.1Q VLAN tag add to an Ethernet frame?

    Answer: 4

    The 802.1Q tag is 4 bytes: a 2-byte TPID (0x8100) and a 2-byte TCI that includes the 12-bit VLAN ID.

  17. Which statement correctly describes BGP?

    Answer: A path-vector protocol that forms sessions over TCP port 179

    BGP is a path-vector protocol that uses the AS_PATH attribute and builds peer sessions over TCP port 179.

  18. An office with 200 private hosts shares one public IPv4 address. Which NAT type is in use?

    Answer: Port Address Translation (NAT overload)

    PAT tells sessions apart by source port numbers, so many inside hosts can share one public IP.

  19. What is the smallest single summary route that covers 192.168.0.0/24 through 192.168.3.0/24?

    Answer: 192.168.0.0/22

    Four contiguous /24 networks share their first 22 bits, so they summarize to 192.168.0.0/22.

  20. In the US, which three 2.4 GHz Wi-Fi channels do not overlap?

    Answer: 1, 6, 11

    With 20 MHz channels 5 MHz apart, channels 1, 6, and 11 are the only non-overlapping set in the FCC band (1–11).

Written and edited by , founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. ikmnet.com — Test delivery, passing score · verified Oct 2026
  2. online.ikmnet.com — Eligibility, exam format, retake policy, score release, time limit · verified Oct 2026