Hydronic Heating Systems Flashcards
7 cards from real HVAC practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Hydronic Heating Systems flashcards as text
What is the typical pH range recommended for water in a closed hydronic heating system?
Answer: 7.0 to 8.5
A slightly alkaline pH of 7.0 to 8.5 helps protect ferrous metals from corrosion while remaining compatible with copper, gaskets, and other system materials.
A condensing boiler in a hydronic system achieves its highest efficiency when return water temperature is below what threshold?
Answer: 120°F
Condensing boilers extract latent heat from flue gases when return water is below approximately 120°F, causing water vapor in the exhaust to condense and release additional BTUs.
What type of valve is used at each terminal unit in a hydronic system to allow the system to be balanced by limiting flow through high-flow circuits?
Answer: Globe valve or circuit setter
Globe valves and circuit setters (calibrated balancing valves) provide precise throttling and are used to balance hydronic systems by restricting flow through over-supplied circuits.
In a two-pipe direct-return hydronic system, why is balancing more difficult compared to a reverse-return system?
Answer: Terminal units closest to the pump have shorter circuits and naturally receive more flow
In a direct-return system, units closest to the pump have the least resistance, so they receive disproportionately high flow and must be throttled back to balance the system.
What safety device is required on every hydronic boiler to prevent catastrophic failure from excessive pressure?
Answer: Pressure relief valve
A pressure relief valve (PRV) is a mandatory safety device that opens automatically to discharge water if system pressure exceeds the rated limit, preventing boiler explosion.
What is the purpose of an automatic water feeder (feed valve) on a hydronic system?
Answer: To replenish water lost through minor system leaks and maintain minimum fill pressure
The automatic water feeder maintains system fill pressure by admitting makeup water from the domestic supply when pressure drops due to minor leaks or normal water loss.
A technician is troubleshooting a hydronic system where one zone heats adequately but a second zone produces no heat despite the circulator running. What should be checked first?
Answer: Zone valve operation and thermostat signal to the valve
When one zone works and another does not, the most likely cause is a failed zone valve that is not opening, or no electrical signal from the thermostat commanding the valve to open.