Practice Test Geeks(HUD) Certified Housing and Urban Development Inspector Practice Test
← All HUD Flashcard Decks

HUD Manufactured Housing Standards Flashcards

6 cards from real HUD practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 HUD Manufactured Housing Standards flashcards as text

  1. What is the primary purpose of the Federal Manufactured Home Construction and Safety Standards (FMHCSS)?

    Answer: To establish minimum construction, safety, and durability standards for manufactured homes

    The FMHCSS establishes preemptive federal standards covering design, construction, strength, durability, fire resistance, and energy efficiency of manufactured homes.

  2. A manufactured home inspector finds that a home's roof trusses are notched to accommodate HVAC ductwork. What should the inspector note?

    Answer: This is a defect because field-notching trusses violates HUD structural standards

    Field-notching or cutting of roof trusses is a structural violation under HUD standards because trusses are engineered components and cannot be altered without engineering approval.

  3. Under the HUD Manufactured Home Installation Program (MHIP), which entity sets minimum installation standards where states have no approved program?

    Answer: HUD directly

    Where states lack an approved installation program, HUD's own minimum standards under the MHIP apply to ensure safe installation of manufactured homes.

  4. Which document serves as the factory's certification that a manufactured home section was inspected and complies with HUD standards?

    Answer: HUD Certification Label and Data Plate together

    Together, the HUD Certification Label (red label on exterior) and the Data Plate (inside the home) certify federal standards compliance for each manufactured home section.

  5. What is the maximum allowable moisture content for lumber used in the structural framing of a HUD-code manufactured home at the time of installation?

    Answer: 19%

    HUD standards require that structural lumber used in manufactured homes have a moisture content no greater than 19% at the time of fabrication or installation.

  6. Which of the following best describes a 'multi-section' manufactured home for HUD inspection purposes?

    Answer: A home consisting of two or more transportable sections joined on-site

    A multi-section (double-wide or triple-wide) manufactured home is factory-built as two or more separate transportable units that are joined together at the installation site.

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. hud.gov — Eligibility, exam information · verified Nov 2026
  2. hudexchange.info — Test delivery · verified Nov 2026