Antennas and Transmission Lines Flashcards
7 cards from real GROL practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Antennas and Transmission Lines flashcards as text
What does a standing wave ratio (SWR) of 1:1 indicate on a transmission line?
Answer: Perfect impedance match with maximum power transfer and no reflected power
An SWR of 1:1 means the transmission line and antenna impedances are perfectly matched, so no power is reflected and all power transfers to the antenna.
What is the characteristic impedance of coaxial cable most commonly used in commercial radio transmitter installations?
Answer: 50 ohms
50-ohm coaxial cable is the industry standard for commercial RF transmitter feedlines due to its balance of low loss and adequate power-handling capacity.
What happens to RF power when there is an impedance mismatch between a transmission line and an antenna?
Answer: Standing waves are created and some power is reflected back toward the transmitter
Impedance mismatch causes a portion of the forward power to be reflected at the antenna feedpoint, creating standing waves and reducing radiated power.
What is the velocity factor of a transmission line?
Answer: The ratio of signal propagation speed in the line to the speed of light in free space
Velocity factor is the ratio of signal speed inside the transmission line to the speed of light in vacuum, typically 0.66–0.95 for common coaxial cables.
What is the primary risk of operating a transmitter into a high SWR load?
Answer: Excessive reflected power can overheat and damage the transmitter's final amplifier
High SWR returns significant reflected power to the transmitter, potentially causing excessive voltage or current that can destroy the final amplifier stage.
An antenna tuner (matching network) is primarily used to:
Answer: Transform the antenna impedance to match the transmission line and transmitter output
An antenna tuner uses inductors and capacitors to transform the impedance presented by the antenna to the value required by the feedline and transmitter, reducing SWR.
Which transmission line type generally offers the lowest attenuation per unit length at UHF frequencies for high-power commercial use?
Answer: Rigid coaxial line or waveguide
Rigid coaxial lines and waveguides offer the lowest loss per unit length at UHF/microwave frequencies, making them the choice for high-power broadcast and radar installations.