G60 Basic Codes & Regulations 5

Question 1

According to FDNY regulations, a hot work permit application must be submitted how far in advance of the planned torch operation?

Accepted Answer

At least one business day before work begins

Answer

FDNY requires hot work permit applications to be submitted at least one business day before operations begin to allow for review and issuance.

Question 2

Which code requirement addresses the use of approved regulators on compressed gas cylinders used for torch work?

Accepted Answer

OSHA 29 CFR 1926.350(h)

Answer

OSHA 29 CFR 1926.350(h) specifically requires that approved pressure-reducing regulators be used on all compressed gas cylinders for torch and welding work.

Question 3

If a G60 certificate of fitness expires during an ongoing job, the certificate holder must:

Accepted Answer

Cease torch operations until the certificate is renewed

Answer

An expired G60 certificate renders the holder unauthorized to conduct torch operations — work must stop until the certificate is renewed.

Question 4

Under NYC fire code, combustible materials in a torch work area that cannot be removed must be protected by:

Accepted Answer

Fire-resistant shields or covers rated for welding/cutting sparks

Answer

When combustible materials cannot be removed from the work area, they must be covered with fire-resistant welding blankets or shields rated for cutting and welding spark exposure.

Question 5

Which of the following actions violates NFPA 51B during torch cutting work?

Accepted Answer

Cutting through a wall without checking the other side for combustibles

Answer

NFPA 51B requires that both sides of any wall or partition be inspected for combustibles before torch cutting — cutting blindly is a code violation.

(G60) Certificate of Fitness for Torch Use of Flammable Gases Practice Test

(G60) Certificate of Fitness for Torch Use of Flammable Gases Practice Test

G60 Basic Codes & Regulations 5