Free TN LLE Services, Feeders, Branch Circuits Questions and Answers

Question 1

An overhead service drop, with a voltage not exceeding 300V between conductors, passes over a residential roof with a 3-in-12 pitch. According to NEC 230.24(A), what is the minimum vertical clearance that must be maintained above the roof surface?

Accepted Answer

8 feet

Answer

NEC 230.24(A) generally requires an 8-foot vertical clearance over roofs. An exception exists for roofs with a slope of 4 in 12 or greater, which allows a reduction to 3 feet. Since the roof pitch is 3-in-12 (less than 4-in-12), the general requirement of 8 feet applies.

Question 2

An electrician is installing a 120/240V multiwire branch circuit to supply two separate kitchen countertop receptacle circuits. Which of the following is an NEC requirement for this type of circuit?

Accepted Answer

A means must be provided to simultaneously disconnect all ungrounded conductors.

Answer

NEC 210.4(B) requires that for multiwire branch circuits, a means must be provided to simultaneously disconnect all ungrounded conductors where the circuit originates. This is typically accomplished with a two-pole circuit breaker or two single-pole breakers with an approved handle tie.

Question 3

What is the minimum feeder conductor ampacity required for a load consisting of a 40-amp continuous load and a 30-amp noncontinuous load?

Accepted Answer

80 amps

Answer

According to NEC 215.2(A)(1), the feeder ampacity must be not less than the noncontinuous load plus 125% of the continuous load. Calculation: (1.25 x 40A) + 30A = 50A + 30A = 80A.

Question 4

According to NEC 230.70(A)(1), where must the service disconnecting means for a one-family dwelling be located?

Accepted Answer

At a readily accessible location either outside or inside nearest the point of conductor entrance.

Answer

NEC 230.70(A)(1) mandates that the service disconnect be installed in a readily accessible location. This can be on the exterior of the building or just inside, nearest the point where the service conductors enter, to limit the amount of unprotected service conductor inside the structure.

Question 5

When calculating the load for a branch circuit supplying a fixed multioutlet assembly (e.g., plugmold) in a commercial building where appliances are not likely to be used simultaneously, what is the standard load allowance per section?

Accepted Answer

180 VA for every 5-foot section or fraction thereof

Answer

NEC 220.14(H)(1) specifies that for a fixed multioutlet assembly where simultaneous use is unlikely, each 5-foot section (or any fraction of a 5-foot section) is calculated at 180 volt-amperes.

TN LLE - Tennessee Limited Licensed Electrician Practice Test

TN LLE - Tennessee Limited Licensed Electrician Practice Test

Free TN LLE Services, Feeders, Branch Circuits Questions and Answers