To calculate the resistance of a light bulb, you can use Ohm's Law:
Resistance (R) = Voltage (V) / Current (I)
Given that the light bulb is rated at 80 watts and 120 volts, you can find the current using the formula for power:
Power (P) = Voltage (V) × Current (I)
Solving for current:
Current (I) = Power (P) / Voltage (V) = 80 W / 120 V = 0.666... A (approximately)
Now, you can use Ohm's Law to find the resistance:
Resistance (R) = Voltage (V) / Current (I) = 120 V / 0.666... A ≈ 180 ohms
So, the resistance of the 80-watt light bulb rated at 120 volts is approximately 180 ohms.
When a single equipment grounding conductor is connected to multiple branch circuits in the same raceway or cable, it should be sized based on the largest overcurrent device protecting the conductors in that raceway or cable. This ensures that the equipment grounding conductor can effectively carry fault currents in the event of a fault and provide proper grounding and safety for all the connected circuits.
Flexible cords are not permitted to be used as a substitute for the fixed wiring of a structure. They are designed for temporary connections, such as supplying power to portable appliances, equipment, or devices, and should not be used as a permanent wiring solution in place of proper fixed wiring installations. Using flexible cords in place of fixed wiring can pose safety hazards and increase the risk of fire or electrical accidents.
The standard ampere ratings for fuses and circuit breakers. A circuit breaker with an ampere rating of 75 amperes is not a standard ampere rating.
The sinusoidal AC low voltage contact limit is commonly considered to be around 15 volts RMS (Root Mean Square) to ensure safety when individuals come into contact with electrical systems or equipment. This level of voltage is generally considered to pose a low risk of causing harm.
A storage battery used for emergency loads should be able to provide at least 87.5% of the rated voltage of the emergency load.
To find the full-load current rating of the single-phase transformer apply the single-phase current formula as shown:I = (150 kVA x 1000) / 240 volts = 15,000/240 = 625 amperes
The over current device rating must not be greater than panel board rating in which it is located
Aluminum is generally not recommended as a material for grounding electrodes in electrical systems. This is because aluminum tends to corrode more quickly compared to other metals like copper or galvanized steel when exposed to the elements and the surrounding environment. Corrosion can lead to an increase in the resistance of the grounding system, reducing its effectiveness. Copper and galvanized steel are commonly used for grounding electrodes due to their better corrosion resistance and conductivity.
The vertically run metal wireways shall be securely supported at intervals not exceeding 15 feet of wireway and shall not have more than one joint between supports.
