Free FCTC Test Verbal and Visual Information Questions and Answers

Question 1

Study the provided diagram of a fire hydrant. Which labeled component must be turned by a firefighter to open the main valve and permit water to flow into the hydrant barrel?

Accepted Answer

Operating Nut

Answer

The operating nut, located at the very top of the hydrant, is specifically designed to be turned with a hydrant wrench. This action manipulates the internal valve stem, opening the main valve at the base and allowing water to flow.

Question 2

Review the provided table, which shows the required pump discharge pressure (PDP) to achieve a desired nozzle pressure for different lengths of 1.75-inch hoseline. What is the correct PDP for a 250-foot hoselay to achieve a 100 PSI nozzle pressure?

Accepted Answer

185 PSI

Answer

By finding the row for '250 feet' and the column for '100 PSI Nozzle Pressure', you can cross-reference the correct value. The table indicates that for a 250-foot hoselay, a Pump Discharge Pressure of 185 PSI is required to overcome friction loss and supply the nozzle with 100 PSI.

Question 3

A fire is reported at the 'Office Building' on the corner of Oak Avenue and 2nd Street. Your engine is staged at the hydrant located at the corner of Main Street and 1st Street. Based on the provided map, what is the most direct route to the incident?

Accepted Answer

Proceed east on 1st Street, then turn north on 2nd Street.

Answer

The hydrant is at Main and 1st. The fire is at Oak and 2nd. The most direct path is to travel one block east on 1st Street to 2nd Street, then travel one block north on 2nd Street to the intersection of Oak Avenue.

Question 4

Examine the bar chart, which displays the number of training hours completed by an engine company in four different subjects last month. Which of the following statements is an accurate conclusion based on the chart's data?

Accepted Answer

Driver Training accounted for exactly half the hours of Forcible Entry training.

Answer

The chart shows Driver Training at 10 hours and Forcible Entry at 20 hours. Therefore, Driver Training hours are exactly half of the Forcible Entry hours. Other options are incorrect based on the visual data (e.g., EMS has 25 hours, which is the most, but not more than the other three combined).

Question 5

Read the following procedure for cleaning a Self-Contained Breathing Apparatus (SCBA) facepiece: 'First, disconnect the regulator from the facepiece. Second, wash the facepiece with a mixture of warm water and approved mild soap. Third, rinse the facepiece thoroughly with clean water to remove all soap residue. Fourth, immerse the facepiece in an approved sanitizing solution for the manufacturer-specified time. Finally, allow the facepiece to air dry completely before returning it to service.' According to this procedure, what step is performed immediately after washing the facepiece with soap and water?

Accepted Answer

Rinsing the facepiece with clean water.

Answer

The procedure explicitly states that the third step, which immediately follows the second step (washing), is to 'rinse the facepiece thoroughly with clean water to remove all soap residue.'

FCTC Test Practice Test

FCTC Test Practice Test

Free FCTC Test Verbal and Visual Information Questions and Answers