Technical Reading and Recall Flashcards
7 cards from real FCTC practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Technical Reading and Recall flashcards as text
A standard operating procedure states: 'Upon arrival, the incident commander shall establish command, conduct a size-up, and transmit an initial report within 90 seconds.' What is the time limit for transmitting the initial report?
Answer: 90 seconds
The SOP specifies the initial report must be transmitted within 90 seconds of arrival.
A fire department manual states that ladders must be inspected after each use, monthly, and annually. Which of the following inspection schedules is NOT mentioned?
Answer: Weekly
The manual specifies inspections after each use, monthly, and annually — weekly is not mentioned.
According to a safety bulletin: 'Personnel entering an IDLH atmosphere must use SCBA, maintain buddy system contact, and carry a personal alert safety system (PASS) device.' How many requirements are stated?
Answer: Three
The bulletin lists three requirements: SCBA use, buddy system contact, and carrying a PASS device.
A hose specification reads: '2½-inch attack line — rated for 400 PSI service pressure, tested at 600 PSI.' The test pressure is how much higher than the service pressure?
Answer: 200 PSI
600 PSI (test) minus 400 PSI (service) equals a difference of 200 PSI.
A policy document states firefighters must complete recertification every two years, with a written exam and a practical skills evaluation. Which component is NOT required for recertification?
Answer: Physical fitness test
The policy specifies a written exam and practical skills evaluation — a physical fitness test is not mentioned.
A technical manual states: 'The thermal imaging camera battery provides approximately 2.5 hours of continuous operation and should be recharged when the indicator shows below 25%.' At what indicator level should recharging begin?
Answer: 25%
The manual specifies recharging should begin when the battery indicator shows below 25%.
An apparatus specification document lists the following pump capacities: 1,500 GPM at 150 PSI, 70% capacity at 200 PSI, and 50% capacity at 250 PSI. What is the rated capacity at 150 PSI?
Answer: 1,500 GPM
The specification explicitly states the pump is rated at 1,500 GPM at 150 PSI.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy
- fctconline.org — Test delivery, exam format, passing score, registration, retake fee, retake policy, score release, score validity, eligibility, time limit · verified Nov 2026