F89 Fire Command Center Operations

Question 1

When a fire alarm activates in a high-rise building, what is the Fire and Life Safety Director's FIRST action at the Fire Command Center?

Accepted Answer

Acknowledge the alarm at the FCC panel, identify the activated device and its location, and initiate investigation

Answer

The FLSD must first acknowledge the alarm to confirm receipt, then identify the specific device (smoke detector, pull station, sprinkler flow switch) and its exact floor and zone. Only after identifying the source can an appropriate response be determined. Silencing before investigation could mask a real fire; full evacuation before verification is premature.

Question 2

The Fire Command Center's public address (PA) system is used during a fire emergency primarily to:

Accepted Answer

Communicate real-time instructions to specific floors or the entire building using the FLSD's voice

Answer

The PA system at the FCC allows the FLSD to broadcast live voice instructions — whether to specific zones (the alarm floor and floors above/below) or building-wide. This is critical for directing occupants to evacuate, shelter-in-place, or remain calm. It does not contact FDNY (that is a separate alarm transmission) or control elevators.

Question 3

A sprinkler flow alarm activates on the 18th floor of a high-rise building. The FLSD investigates via phone to the floor warden and learns a sprinkler head activated due to accidental damage. What FCC action is appropriate after FDNY has inspected and authorized reset?

Accepted Answer

Reset the alarm panel and restore the sprinkler system to normal service only after FDNY authorizes and the system is back in working order

Answer

Alarm panel reset must only occur after FDNY has inspected, the impairment is resolved, and FDNY authorizes the reset. Resetting before FDNY authorization is a violation; leaving the panel in alarm indefinitely impairs the building's ability to detect future events. The FLSD — not a remote party — performs the reset at the FCC.

Question 4

Which of the following is NOT typically a function displayed or controlled at the Fire Command Center panel?

Accepted Answer

Individual occupant temperature readings from office thermostats

Answer

The FCC integrates life safety systems: alarm annunciation, elevator recall, smoke control fans, pressurization systems, and communication systems. It does not monitor HVAC comfort systems or individual office thermostats — those are building management system functions unrelated to life safety.

Question 5

During a working fire on the 10th floor of a high-rise, the FDNY Incident Commander arrives at the Fire Command Center. What is the FLSD's role at that point?

Accepted Answer

Remain at the FCC as a resource, operate systems at the Incident Commander's direction, and provide building information

Answer

Once FDNY arrives, the Incident Commander assumes command of the emergency. The FLSD remains at the FCC to operate systems (elevators, PA, smoke control) as directed by FDNY and to provide expert knowledge of the building's systems and layout. The FLSD does not leave, take independent action, or impede FDNY access.

F89 - Fire and Life Safety Director Practice Test

F89 - Fire and Life Safety Director Practice Test

F89 Fire Command Center Operations