F80 F80 Inspection Procedures 3

Question 1

Which of the following is the correct method for testing parking brake effectiveness during an F80 inspection?

Accepted Answer

Apply the parking brake and attempt to drive forward on flat ground

Answer

Measure the distance the vehicle rolls after the parking brake is released

Answer

Inspect only the parking brake cable for fraying

Answer

Verify only that the parking brake lever moves up and down

Question 2

What is the acceptable minimum tire tread depth for a vehicle to pass an F80 inspection?

Accepted Answer

2/32 inch (1.6 mm)

Answer

1/16 inch (1.6 mm)

Answer

4/32 inch (3.2 mm)

Answer

6/32 inch (4.8 mm)

Question 3

During an F80 exhaust inspection, which condition is grounds for rejection?

Accepted Answer

Exhaust leaks forward of the last point of exit from the passenger compartment

Answer

A muffler that reduces exhaust noise

Answer

Exhaust that exits at the rear of the vehicle

Answer

A catalytic converter in good working order

Question 4

When an inspector checks suspension components during an F80 inspection, what is the correct tool used to check for worn ball joints?

Accepted Answer

A pry bar and dial indicator or equivalent lift test

Answer

A torque wrench

Answer

A feeler gauge only

Answer

A tire pressure gauge

Question 5

Which fuel system condition would cause a vehicle to fail an F80 inspection?

Accepted Answer

Fuel odor or visible fuel leakage anywhere in the system

Answer

A fuel cap that snaps closed

Answer

A fuel tank with less than a quarter tank of fuel

Answer

A fuel injector that is slightly dirty

Question 6

How are wiper blades evaluated during an F80 windshield wiper inspection?

Accepted Answer

They are tested on the windshield for proper contact and streak-free wiping

Answer

Only their mounting hardware is checked for tightness

Answer

Their age in years is compared to manufacturer recommendations

Answer

Only the wiper motor speed is tested

Question 7

Which of the following seat belt conditions results in an F80 inspection failure?

Accepted Answer

A belt that does not retract, latch, or has visible webbing damage

Answer

A belt with a slight color fade from sun exposure

Answer

A belt that locks during hard braking

Answer

A belt with a manufacturer's logo worn off