Mixed Deck — All F04 Topics Flashcards

Under FDNY regulations, what is the minimum clear width required for a main aisle in a place of public assembly?

Answer: 44 inches

FDNY and NYC Building Code require main aisles in places of assembly to maintain a minimum clear width of 44 inches to allow safe egress.

An F-04 Fireguard is inspecting a large tent set up for a weekend festival. Which of the following is NOT a required part of the pre-event safety inspection?

Answer: Confirming the structural integrity of the main tent poles.

While overall safety is a concern, the F-04 Fireguard's role is focused on fire safety. The structural integrity of tent poles is the responsibility of the tent installation company and the Department of Buildings (DOB) inspectors. The fireguard's inspection focuses specifically on fire hazards, egress, and fire protection equipment.

What does 'listed' mean when referring to fire protection equipment?

Answer: The equipment has been evaluated by a recognized testing laboratory and meets applicable standards

Listed equipment has been tested by an approved testing laboratory (such as UL or FM) and found to meet performance standards for its intended use.

During an evacuation, a staff warden discovers a stairwell is filled with smoke. What should be done?

Answer: Close the stairwell door and direct occupants to an alternate stairwell

A smoke-filled stairwell must not be used; wardens should close the door to contain the smoke and redirect occupants to an alternate exit stairwell.

Who is required by the FDNY to be present during events held at a temporary place of assembly?

Answer: A licensed Fireguard (F-04 certificate holder)

The FDNY requires a licensed Fireguard holding an F-04 certificate to be present during events at a temporary place of assembly.

Which of the following is grounds for denial of a Certificate of Fitness application?

Answer: Providing false information on the application

Providing false or misleading information on a Certificate of Fitness application is grounds for denial or revocation.

The FDNY requires that fire alarm pull stations in a place of assembly be:

Answer: Unobstructed, visible, and accessible at all times during occupancy

Pull stations must always be visible and immediately accessible so occupants can activate the alarm without delay during an emergency.

Which of the following is a critical proactive duty of an F-04 Fireguard specifically related to crowd management BEFORE an event begins?

Answer: Conducting a final walkthrough to ensure all exit paths and aisles are completely clear of obstructions.

A primary responsibility of a fireguard and crowd manager is to inspect the area of responsibility before attendees arrive to identify and address any egress barriers. Ensuring that all means of egress, such as aisles and exit doors, are unobstructed is a fundamental step in crowd management and safety.

Which of the following instructions should an F04 Fireguard give to evacuating occupants during a fire emergency?

Answer: "Close all doors behind you as you leave and do not use the elevators."

During a fire, elevators must not be used as they can malfunction and trap occupants. Closing doors helps to confine the fire and smoke. Occupants should evacuate via the nearest safe exit, not just the main entrance.

The F-04 Certificate of Fitness is specifically required for individuals maintaining fire safety at which type of location?

Answer: Temporary place of assembly events, such as festivals or outdoor concerts, with a TPA permit.

The F-04 Certificate of Fitness is specifically for personnel responsible for fire safety at TEMPORARY place of assembly events that operate under a TPA (Temporary Place of Assembly) permit.

What is required before a Certificate of Fitness holder can be reassigned to perform a different type of regulated duty?

Answer: They must obtain the appropriate Certificate of Fitness for that specific duty

A Certificate of Fitness is specific to the duties listed on it; performing different regulated duties requires obtaining the appropriate certificate for those duties.

What is the correct PASS technique for using a fire extinguisher?

Answer: Pull, Aim, Squeeze, Sweep

PASS stands for Pull the pin, Aim at the base, Squeeze the handle, and Sweep side to side across the base of the fire.

A fireguard discovers that emergency lighting is not functioning before an event. What is the required action?

Answer: Report it immediately to the supervisor and ensure it is repaired before the event opens

Non-functional emergency lighting must be repaired before occupants are admitted, as it is essential for safe evacuation.

What should a Fireguard do if they discover that a fire door is being held open with a wedge or other object?

Answer: Remove the obstruction immediately to restore the door's fire-resistance function

Propped-open fire doors defeat compartmentalization and must be immediately closed; the Fireguard should also document and report the violation.

During your patrol you find a stairwell fire door held open with a rubber wedge. What should you do?

Answer: Remove the wedge so the door can self-close and latch

Self-closing fire doors must close and latch to keep smoke and fire out of the stairwell, so the wedge must be removed right away.

Where should portable fire extinguishers be positioned in a temporary place of assembly?

Answer: Mounted in visible, accessible locations near exits and potential hazard areas

Fire extinguishers must be mounted in visible and accessible locations near exits and hazard areas so staff can reach them quickly without delay.

What should a staff warden do if they encounter heavy smoke while conducting a floor sweep?

Answer: Immediately retreat, close doors behind them, and report conditions to the Fire Safety Director

If a warden encounters heavy smoke, they must retreat immediately, close doors to contain the smoke, and report conditions to the Fire Safety Director rather than risk their own life.

A fire starts in a trash compactor room. What type of extinguisher is most appropriate?

Answer: Class A dry chemical or water extinguisher

Trash compactor fires involve ordinary combustibles (Class A materials), making a Class A dry chemical or water extinguisher the appropriate choice.

What is a 'hot work' hazard in the context of fire safety at assembly venues?

Answer: Activities involving open flames or sparks, such as welding or cutting

Hot work activities generate sparks or open flame and must be strictly controlled near any combustible materials in a venue.

During a pre-event inspection, you find an exit door chained shut with a padlock. What is the FIRST action you must take?

Answer: Immediately notify management and require the chain be removed before guests enter

A locked exit is an immediate life-safety hazard that must be corrected before any occupants are admitted to the space.