F-03 Fire Alarm Systems and Notification Procedures 1

Question 1

When a fire alarm activates at a place of assembly, what is the Fire Guard's FIRST priority?

Accepted Answer

Notify occupants and begin evacuation procedures

Answer

Reset the alarm panel immediately

Answer

Wait for FDNY to arrive before taking action

Answer

Silence the alarm to prevent panic

Question 2

Which of the following best describes the purpose of a manual pull station in a fire alarm system?

Accepted Answer

It allows any person to manually initiate a fire alarm signal

Answer

It automatically calls the FDNY when activated

Answer

It resets the sprinkler system after a discharge

Answer

It controls the building's emergency lighting

Question 3

A fire alarm has sounded and the Fire Guard investigates but finds no fire. What should the Fire Guard do?

Accepted Answer

Notify FDNY and log the event in the logbook

Answer

Reset the alarm without notifying anyone

Answer

Ignore the alarm since no fire was found

Answer

Only notify the building manager and take no further action

Question 4

Under NYC Fire Code, who is responsible for maintaining fire alarm systems in a place of assembly in working order?

Accepted Answer

The building owner or operator

Answer

The Fire Guard on duty

Answer

The FDNY

Answer

The event organizer

Question 5

What does a 'trouble signal' on a fire alarm control panel indicate?

Accepted Answer

A system fault or supervisory condition requiring attention

Answer

A fire has been detected by a smoke detector

Answer

All clear after a fire alarm has been silenced

Answer

The fire suppression system has been activated

Question 6

How should a Fire Guard respond if the fire alarm control panel shows a 'supervisory' signal?

Accepted Answer

Investigate the cause and notify the appropriate party, then log the event

Answer

Treat it the same as a full fire alarm and evacuate

Answer

Ignore it unless a second alarm sounds

Answer

Immediately shut down all building systems

Question 7

Which type of fire alarm detector is most commonly triggered by visible particles of combustion?

Accepted Answer

Smoke detector

Answer

Heat detector

Answer

Flame detector

Answer

Carbon monoxide detector