← All F-01 Flashcard Decks

F-01 Fireguard System Impairment Procedures Flashcards

7 cards from real F-01 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 F-01 Fireguard System Impairment Procedures flashcards as text
  1. When a sprinkler system is placed out of service for maintenance, the fireguard must notify which agency first?

    Answer: The Fire Department and the Bureau of Fire Prevention

    FDNY and the Bureau of Fire Prevention must be notified whenever a fire suppression system is impaired.

  2. A fire watch patrol during a system impairment must be conducted at minimum every:

    Answer: 30 minutes

    FDNY regulations require a fire watch patrol at least every 30 minutes during any system impairment.

  3. Which document must the fireguard maintain to record all fire watch patrols during a system impairment?

    Answer: Impairment log or fire watch log

    An impairment log or fire watch log documenting time, route, and findings must be kept throughout the impairment.

  4. If a fireguard discovers a new fire hazard during a fire watch patrol, what is the immediate first step?

    Answer: Alert occupants and notify the fire department immediately

    Immediate notification of occupants and the fire department is required upon discovery of any fire hazard.

  5. Who is authorized to restore a fire suppression system to service after an impairment?

    Answer: A licensed sprinkler contractor or qualified maintenance personnel

    Only a licensed sprinkler contractor or qualified maintenance personnel may restore an impaired suppression system.

  6. Which area should the fireguard pay particular attention to during a fire watch when a dry-pipe sprinkler system is impaired in winter?

    Answer: Cold or unheated spaces where pipes could freeze if wet-pipe backup is used

    During winter, unheated areas are especially vulnerable to pipe freezing issues if temporary wet-pipe measures are introduced.

  7. An impairment tag (also called an impairment coordinator tag) must be attached to:

    Answer: The control valve that has been shut off

    The impairment tag must be attached directly to the control valve that was closed to identify the impaired section.