Installation & Assembly Techniques Flashcards
7 cards from real EPA 608 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Installation & Assembly Techniques flashcards as text
Why should dry nitrogen be flowed through copper tubing while brazing?
Answer: To prevent oxide scale from forming inside the tube
Nitrogen displaces air so internal copper oxide scale does not form and later contaminate the system.
Which filler metal can braze copper to copper without added flux?
Answer: Phosphorus-copper (BCuP) alloy
Phosphorus-copper alloys are self-fluxing on copper-to-copper joints.
Brazing is distinguished from soldering by filler metal that melts above what temperature?
Answer: 840°F
By definition, brazing uses filler that melts above 840°F (450°C), while soldering is below it.
When brazing copper to steel or brass, what is generally required?
Answer: A silver-bearing (BAg) alloy with flux
Phosphorus-copper alloys form brittle compounds on ferrous metals, so silver alloy and flux are used.
How should a thermostatic expansion valve or service valve be protected while brazing nearby?
Answer: Wrap it with a wet rag or heat-absorbing paste
A heat sink absorbs heat so seals, seats and internal parts are not damaged.
What is the standard flare angle for refrigeration flare fittings?
Answer: 45 degrees
SAE flare fittings used in refrigeration are made at 45 degrees.
When making a flare connection, what must be done before flaring the tube end?
Answer: Slip the flare nut onto the tube first
The flare nut cannot be installed over the flared end afterward, so it goes on first.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. Exam facts are checked against the official sources linked below. Editorial policy
Sources & references
Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy