ELDT - Entry Level Driver Training Entry Level Driver Training Coupling and Uncoupling 1

Question 1

When connecting air lines to a trailer during coupling, which hose should be connected first?

Accepted Answer

The emergency (blue) glad hand first

Answer

The emergency (blue) glad hand should be connected first. If the service line were connected first and the emergency line were left disconnected, the trailer brakes would release, creating a runaway hazard. Connecting emergency first keeps the trailer brakes applied until the system is fully connected.

Question 2

What should you do with the tractor parking brakes before beginning the uncoupling process?

Accepted Answer

Apply them to hold the rig in place

Answer

The tractor parking brakes must be applied before uncoupling begins. This prevents the tractor from moving unexpectedly while you are disconnecting the kingpin, air lines, and electrical connections, which could cause serious injury.

Question 3

Before backing under a trailer to couple, you should inspect the fifth wheel plate and ensure it is:

Accepted Answer

Properly lubricated to allow smooth coupling and reduce wear

Answer

The fifth wheel plate must be properly lubricated before coupling. Adequate lubrication reduces wear on both the fifth wheel and the kingpin, ensures the kingpin seats correctly, and allows proper trailer articulation during turns.

Question 4

After fully coupling a tractor to a trailer, what is the correct procedure for raising the landing gear?

Accepted Answer

Raise it completely and secure the crank handle

Answer

Landing gear must be raised completely before driving. Partially raised landing gear can strike the ground on dips or bumps, causing loss of control or structural damage. The crank handle must also be stored securely so it cannot fall and become a road hazard.

Question 5

During the uncoupling process, when is the correct time to disconnect the air lines and electrical cord?

Accepted Answer

After the landing gear is down but before releasing the fifth wheel

Answer

Air lines and the electrical cord should be disconnected after the landing gear is lowered and supporting the trailer but before releasing the fifth wheel latch. This sequence ensures the trailer is stable before you remove connections, and prevents the lines from being dragged when the tractor pulls away.

Entry Level Driver Training (ELDT) Practice Test

Entry Level Driver Training (ELDT) Practice Test

ELDT - Entry Level Driver Training Entry Level Driver Training Coupling and Uncoupling 1