CTSP Hazard Identification and Control Questions and Answers

Question 1

A tree crew is tasked with removing a large oak tree located in a tight residential space with a house on one side and a garage on the other. According to the hierarchy of hazard controls, which of the following actions represents the most effective control measure the crew could implement?

Accepted Answer

Using a crane to lift sections of the tree out, instead of felling or dropping them.

Answer

The hierarchy of controls ranks methods from most to least effective: Elimination, Substitution, Engineering Controls, Administrative Controls, and PPE. Using a crane is an engineering control that redesigns the work process to remove the hazard of uncontrolled falling sections, making it more effective than administrative controls (briefing, work zones) or PPE (hard hats).

Question 2

Before beginning any tree care operation, the ANSI Z133 standard requires a worksite assessment to identify potential hazards. Which of the following is a required component of this initial inspection?

Accepted Answer

Determining if any electrical hazards exist.

Answer

According to the ANSI Z133 standard, a crucial first step before work begins is a thorough site assessment to identify hazards. A key component of this is to inspect for the presence of electrical hazards, as contact with energized conductors is a leading cause of fatalities in arboriculture.

Question 3

A ground worker is tasked with operating a brush chipper. Which hazard control measure is an example of an administrative control for this task?

Accepted Answer

Training the worker on the proper procedures for feeding material and using the emergency shut-off.

Answer

Administrative controls are work practices and procedures that reduce exposure to a hazard. Training on correct procedures is a classic example of an administrative control. The feed guard is an engineering control, the gear is PPE, and replacing the chipper is an example of substitution.

Question 4

A CTSP is investigating a near-miss incident where a climber almost came in contact with a secondary power line that was partially obscured by foliage. To prevent a recurrence, which of the following is the MOST critical action to reinforce with all crews?

Accepted Answer

Treating all overhead lines as energized until confirmed otherwise by the utility provider.

Answer

The foundational safety principle for electrical hazards, as outlined in ANSI Z133 and OSHA guidelines, is to assume all lines are energized with potentially fatal voltages. This mindset is the most critical preventative measure. While the other options are important controls (PPE, administrative), the fundamental assumption of danger is paramount.

Question 5

During a job briefing for a roadside pruning operation, which of the following topics is specifically required by ANSI Z133 to be communicated to all affected workers?

Accepted Answer

Hazards associated with the job and special precautions.

Answer

The ANSI Z133 standard mandates that a job briefing be performed before the start of each job. This briefing must be communicated to all affected workers and cover specific subjects, including hazards associated with the job, work procedures, special precautions, electrical hazards, job assignments, and PPE requirements.

CTSP - Certified Treecare Safety Professional Practice Test

CTSP - Certified Treecare Safety Professional Practice Test

CTSP Hazard Identification and Control Questions and Answers