โ† All CTP Flashcard Decks

Technical Documentation & Standards Flashcards

7 cards from real CTP practice questions. Tap to flip, then mark Knew It or Still Learning โ€” missed cards come back until you master them.

Read the first 7 Technical Documentation & Standards flashcards as text
  1. Which organization publishes the National Electrical Code (NEC), referenced as NFPA 70?

    Answer: National Fire Protection Association

    The NEC is developed and published by the National Fire Protection Association as NFPA 70.

  2. In a document's revision history table, which information is MOST essential to include?

    Answer: The revision level, date, description of the change, and approver

    A revision history should record what changed, when, at which revision, and who approved it.

  3. What is the main difference between a standard and a specification?

    Answer: A standard is a widely agreed set of requirements, while a specification spells out the requirements for a particular product or project

    Standards give broad agreed criteria, while specifications state the exact requirements a given item must meet, often by citing standards.

  4. An auditor asks for objective evidence that a procedure was followed. Which item is the best example?

    Answer: A completed, signed, and dated checklist or record

    Completed records show what was actually done, which makes them objective evidence, while the procedure only shows what should be done.

  5. On a schematic or drawing, what does the abbreviation "TYP" next to a dimension mean?

    Answer: The dimension applies to all similar features unless noted otherwise

    TYP (typical) means the dimension applies to all identical features shown.

  6. Which readability approach is recommended for technical manuals written for a wide audience?

    Answer: Use plain language, define terms when first used, and keep sentences short

    Plain language, defined terms, and short sentences make manuals easier to read and lower the chance of mistakes.

  7. What is the purpose of a redline markup on a drawing?

    Answer: To show approved changes or field changes so the official drawing can be updated

    Redlines record changes, such as as-built conditions, that must be formally added into the controlled drawing.

Written and edited by , founder of Practice Test Geeks, with AI assistance. We have not yet matched this exam's facts to an official source, so confirm fees, dates and rules with the exam body. Editorial policy