Technical Documentation & Standards Flashcards
7 cards from real CTP practice questions. Tap to flip, then mark Knew It or Still Learning โ missed cards come back until you master them.
Read the first 7 Technical Documentation & Standards flashcards as text
A technician finds that a work instruction posted at a station is Rev C, but the document control system lists Rev D as current. What should the technician do first?
Answer: Stop and obtain the current Rev D before proceeding
Document control requires using only the current approved revision, so obsolete copies must be replaced before work continues.
Which ISO standard sets out the requirements for a quality management system, including control of documented information?
Answer: ISO 9001
ISO 9001 defines QMS requirements, and its clause 7.5 covers creating, updating, and controlling documented information.
In an engineering change process, what is the main purpose of an Engineering Change Notice (ECN)?
Answer: To tell affected parties about an approved change and when it takes effect
An ECN tells stakeholders about an approved change and how and when it will be put in place.
On a technical drawing, where would you normally find the drawing number, revision level, scale, and approval signatures?
Answer: In the title block
The title block, usually in the lower-right corner, holds key identifying information such as the drawing number, scale, revision, and approvals.
Which writing practice makes a step-by-step procedure easiest to follow?
Answer: Starting each step with an action verb in the imperative mood
Imperative steps that begin with an action verb, such as "Tighten the bolt," are clear and direct.
According to ANSI Z535 conventions, which signal word marks a hazardous situation that, if not avoided, WILL result in death or serious injury?
Answer: DANGER
DANGER is kept for the most extreme hazards, where death or serious injury will happen if the hazard is not avoided.
A calibration record is missing the technician's signature and date. What is the biggest problem from a documentation standpoint?
Answer: The record lacks traceability and accountability
Without a signature and date, no one can tell who did the work or when, which breaks traceability.
Written and edited by Nathan Beja, founder of Practice Test Geeks, with AI assistance. We have not yet matched this exam's facts to an official source, so confirm fees, dates and rules with the exam body. Editorial policy