CSWP Configurations 4

Question 1

In a SOLIDWORKS assembly, which of the following CANNOT be independently set per assembly configuration?

Accepted Answer

The file name of a referenced component

Answer

The file name (path) of a referenced component is not configuration-specific; only suppression, referenced configuration, and mate states can vary per assembly configuration.

Question 2

What is the purpose of the 'Configure Component' command in an assembly?

Accepted Answer

To set which part configuration is used by a component across multiple assembly configurations in one dialog

Answer

Configure Component opens a table where you can assign different part configurations to a component across multiple assembly configurations at once.

Question 3

When a component is added to an assembly while only one configuration is active, what is the component's state in all other assembly configurations by default?

Accepted Answer

Suppressed

Answer

By default, components added to one assembly configuration are suppressed in all other existing configurations.

Question 4

Where are exploded views stored in SOLIDWORKS assemblies?

Accepted Answer

Within a specific assembly configuration

Answer

Exploded views are stored inside a specific assembly configuration and are accessible in drawings by referencing that configuration.

Question 5

What is an 'Alternate Position View' in a SOLIDWORKS drawing, and how does it relate to configurations?

Accepted Answer

It shows a second position of an assembly component using a different configuration overlaid on the same view

Answer

An Alternate Position View overlays a second position (from another configuration) on an existing drawing view, commonly used to show range of motion.

(CSWP) SOLIDWORKS CAD Design Professional Practice Test

(CSWP) SOLIDWORKS CAD Design Professional Practice Test

CSWP Configurations 4