CSWP Configurations 4 — Questions and Answers
Question 1: In a SOLIDWORKS assembly, which of the following CANNOT be independently set per assembly configuration?
- The file name of a referenced component (Correct answer)
- The suppression state of a component
- The referenced configuration of a component
- The position of a component via mates
Correct answer: The file name of a referenced component
The file name (path) of a referenced component is not configuration-specific; only suppression, referenced configuration, and mate states can vary per assembly configuration.
Question 2: What is the purpose of the 'Configure Component' command in an assembly?
- To set which part configuration is used by a component across multiple assembly configurations in one dialog (Correct answer)
- To open the referenced part file for editing
- To change the component's color in the current assembly configuration
- To add the component to a new assembly configuration
Correct answer: To set which part configuration is used by a component across multiple assembly configurations in one dialog
Configure Component opens a table where you can assign different part configurations to a component across multiple assembly configurations at once.
Question 3: When a component is added to an assembly while only one configuration is active, what is the component's state in all other assembly configurations by default?
- Suppressed (Correct answer)
- Resolved (fully loaded)
- Lightweight
- Hidden
Correct answer: Suppressed
By default, components added to one assembly configuration are suppressed in all other existing configurations.
Question 4: Where are exploded views stored in SOLIDWORKS assemblies?
- Within a specific assembly configuration (Correct answer)
- As a separate file linked to the assembly
- In the drawing file that references the assembly
- In the Default configuration only
Correct answer: Within a specific assembly configuration
Exploded views are stored inside a specific assembly configuration and are accessible in drawings by referencing that configuration.
Question 5: What is an 'Alternate Position View' in a SOLIDWORKS drawing, and how does it relate to configurations?
- It shows a second position of an assembly component using a different configuration overlaid on the same view (Correct answer)
- It creates a second drawing view using an alternate configuration on a separate sheet
- It switches the entire drawing between two configurations automatically
- It is a special configuration type that stores two positions for animation
Correct answer: It shows a second position of an assembly component using a different configuration overlaid on the same view
An Alternate Position View overlays a second position (from another configuration) on an existing drawing view, commonly used to show range of motion.
Question 6: In the 'Modify Configurations' dialog for an assembly, what parameters can you modify simultaneously across multiple configurations?
- Component suppression states, referenced configurations, and fixed/float status (Correct answer)
- Mate distances, material assignments, and file paths
- Appearance colors, decals, and RealView settings
- Assembly-level equations and global variables only
Correct answer: Component suppression states, referenced configurations, and fixed/float status
The Modify Configurations dialog lets you control suppression, referenced part configuration, and fixed/float state across all assembly configurations in a table.
Question 7: How does a 'Flexible' subassembly behave differently from a 'Rigid' subassembly within an assembly configuration?
- A Flexible subassembly allows its internal component positions to be driven by the parent assembly's mates (Correct answer)
- A Flexible subassembly can switch its own internal configurations independently
- A Flexible subassembly loads only its envelope geometry into the parent assembly
- A Flexible subassembly ignores mate constraints from the parent assembly
Correct answer: A Flexible subassembly allows its internal component positions to be driven by the parent assembly's mates
Setting a subassembly to Flexible allows its internal degrees of freedom to be resolved by mates defined in the parent assembly.
CSWP Configurations 4
In a SOLIDWORKS assembly, which of the following CANNOT be independently set per assembly configuration?