Sweep and Loft Features Flashcards
7 cards from real CSWA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Sweep and Loft Features flashcards as text
What two elements are required at minimum to create a basic Sweep feature in SolidWorks?
Answer: A profile and a path
A sweep requires a profile sketch (cross-section) and a path sketch that the profile follows to create the swept geometry.
In SolidWorks, a Loft feature creates geometry by:
Answer: Blending between two or more profiles
Loft blends between two or more profile sketches to create smooth transitions between different cross-sections.
What is the minimum number of profiles required to create a Loft feature in SolidWorks?
Answer: 2
A loft requires at least two profiles to define the start and end cross-sections of the blended shape.
Which of the following can be used as a Sweep path in SolidWorks?
Answer: An open or closed sketch, or a set of model edges
A sweep path can be an open or closed sketch or a set of model edges, providing flexibility in defining the trajectory of the sweep.
Guide curves in a Sweep feature are used to:
Answer: Control the orientation and shape of the profile along the path
Guide curves control how the profile cross-section changes orientation and shape as it travels along the sweep path.
When creating a Swept Cut in SolidWorks, the feature:
Answer: Removes material by sweeping a profile along a path
A Swept Cut removes material using the same sweep principle as a Boss/Base, but subtracts rather than adds geometry.
A Helix/Spiral curve in SolidWorks is most commonly used as:
Answer: A path for sweep features to create springs or threads
Helix/Spiral curves are typically used as sweep paths to create helical geometry such as springs, coils, and thread profiles.