Dimensions and Annotations Flashcards
6 cards from real CSWA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 6 Dimensions and Annotations flashcards as text
When sketching, a designer adds a dimension that conflicts with existing dimensions and relations. What is this state called, and how does SOLIDWORKS typically indicate it?
Answer: Over-defined, indicated by yellow or red-colored dimensions/relations.
When a dimension or relation is redundant or conflicts with others, the sketch is over-defined. SOLIDWORKS signals this with yellow or red colors to prompt the user to resolve the conflict.
Which of the following best describes a 'driven' or 'reference' dimension in a SOLIDWORKS sketch?
Answer: A read-only dimension that reports a measurement but does not control the sketch geometry.
A driven (or reference) dimension is for measurement purposes only. It is shown in gray and often in parentheses by default and will update if the geometry changes, but it cannot be edited to drive the geometry. This prevents over-defining the sketch.
A designer has created a part using the Hole Wizard to create several counterbore holes. When creating the manufacturing drawing, what is the most efficient and standardized method to add detailed specifications for these holes?
Answer: Use the Hole Callout tool on the Annotation toolbar.
The Hole Callout tool is specifically designed to read the information from a Hole Wizard feature and automatically generate a standardized, detailed note that includes diameter, depth, counterbore/countersink details, and instance counts.
In a SOLIDWORKS sketch, what does the color black signify for sketch entities like lines and arcs?
Answer: The entities are fully defined by dimensions and/or geometric relations.
Black indicates that a sketch entity is fully defined. Its position and size are locked by a combination of dimensions and relations relative to the origin or other defined geometry. Blue indicates it is under-defined.
A designer receives a part file modeled in inches. The drawing requirements specify that all dimensions must be displayed in millimeters with a precision of three decimal places. Where would the designer primarily make this change for the entire document?
Answer: In the Document Properties > Units settings.
Document-wide settings for the primary unit system (like changing from IPS to MMGS) and default precision for dimensions are controlled under Tools > Options > Document Properties > Units.
When creating a drawing, which tool allows a user to automatically import dimensions and tolerances that were created in the 3D part model into a specific drawing view?
Answer: The Model Items tool.
The 'Model Items' command is used to import annotations (dimensions, tolerances, hole callouts, etc.) from the source part or assembly model into the drawing. This promotes design intent and reduces the redundant work of re-dimensioning the drawing from scratch.