CSC Health & Safety Protocols 3

Question 1

A consultant is assessing a site with potential lead paint exposure. Under EPA's Renovation, Repair, and Painting (RRP) Rule, which buildings are covered?

Accepted Answer

Pre-1978 housing and child-occupied facilities

Answer

EPA's RRP Rule applies to pre-1978 housing and child-occupied facilities to protect against lead dust generated during renovation.

Question 2

NIOSH recommends which recommended exposure limit (REL) for respirable crystalline silica to protect workers?

Accepted Answer

0.025 mg/m³ as an 8-hour TWA

Answer

NIOSH recommends a REL of 0.025 mg/m³ as a TWA for respirable crystalline silica, lower than OSHA's PEL, to prevent silicosis.

Question 3

In a sustainability-focused workplace wellness program, 'ergonomics' primarily addresses which category of hazard?

Accepted Answer

Physical hazards related to musculoskeletal strain

Answer

Ergonomics targets physical hazards such as awkward postures, repetitive motion, and forceful exertions that lead to musculoskeletal disorders.

Question 4

Which US federal agency is responsible for setting and enforcing workplace safety standards under the OSH Act of 1970?

Accepted Answer

OSHA

Answer

OSHA (Occupational Safety and Health Administration) within the Department of Labor enforces workplace health and safety regulations.

Question 5

A CSC reviewing a chemical plant's emergency response plan should verify compliance with which EPA regulation governing accidental releases of hazardous substances?

Accepted Answer

Clean Air Act Section 112(r) – RMP Rule

Answer

EPA's Risk Management Program (RMP) Rule under CAA 112(r) requires facilities using extremely hazardous chemicals to develop accident prevention and emergency response plans.

(CSC) Certified Sustainability Consultant Practice Test

(CSC) Certified Sustainability Consultant Practice Test

CSC Health & Safety Protocols 3