CPSI Layout and Site Design Requirements (Use Zones) 2

Question 1

When two swings are installed side-by-side on the same structure, how should the use zones be treated?

Accepted Answer

The use zones may overlap only between the two swings but not with other equipment

Answer

Use zones for swings on the same structure may overlap with each other but must not overlap with use zones of other equipment or structures.

Question 2

A merry-go-round has a diameter of 8 feet. What is the minimum required use zone radius measured from the outer edge of the equipment?

Accepted Answer

6 feet

Answer

For rotating equipment like merry-go-rounds, CPSC guidelines require a minimum use zone of 6 feet beyond the perimeter of the equipment.

Question 3

A composite play structure has multiple elevated exit points at varying heights. Which height is used to calculate the required use zone?

Accepted Answer

The height of the highest designated play surface

Answer

The use zone for a composite structure is based on the height of the highest designated play surface, ensuring adequate fall protection for the worst-case fall.

Question 4

What is the minimum use zone required in front of and behind a belt swing with a pivot point 8 feet high?

Accepted Answer

Twice the height of the pivot point (16 feet) in front and behind

Answer

For swings, the use zone in front and behind equals twice the height of the pivot point, so an 8-foot pivot requires 16 feet of clearance in those directions.

Question 5

A slide structure's use zone at the exit must extend at least how far beyond the end of the slide chute?

Accepted Answer

6 feet

Answer

CPSC guidelines require the use zone at the slide exit to extend at least 6 feet beyond the end of the slide chute to accommodate children's exit trajectory.

CPSI - Certified Playground Safety Inspector Practice Test

CPSI - Certified Playground Safety Inspector Practice Test

CPSI Layout and Site Design Requirements (Use Zones) 2