CPSI Layout and Site Design Requirements (Use Zones) 2

Question 1

When two swings are installed side-by-side on the same structure, how should the use zones be treated?

Accepted Answer

The use zones may overlap only between the two swings but not with other equipment

Answer

Each swing gets an independent use zone that must not overlap with any other equipment

Answer

Use zones can fully overlap between swings since they share a common frame

Answer

The inspector determines overlap allowance based on age group served

Question 2

A merry-go-round has a diameter of 8 feet. What is the minimum required use zone radius measured from the outer edge of the equipment?

Accepted Answer

6 feet

Answer

8 feet

Answer

10 feet

Answer

12 feet

Question 3

A composite play structure has multiple elevated exit points at varying heights. Which height is used to calculate the required use zone?

Accepted Answer

The height of the highest designated play surface

Answer

The average height of all exit points

Answer

The height of the lowest exit point to be conservative

Answer

Each exit point generates its own independent use zone calculation

Question 4

What is the minimum use zone required in front of and behind a belt swing with a pivot point 8 feet high?

Accepted Answer

Twice the height of the pivot point (16 feet) in front and behind

Answer

8 feet in front and behind, measured from directly below the pivot

Answer

6 feet in all directions around the swing

Answer

12 feet in front and behind, measured from directly below the pivot

Question 5

A slide structure's use zone at the exit must extend at least how far beyond the end of the slide chute?

Accepted Answer

6 feet

Answer

3 feet

Answer

4 feet

Answer

8 feet

Question 6

Two adjacent pieces of equipment have use zones that overlap. Which of the following is the correct remedy?

Accepted Answer

Reposition one or both pieces of equipment to eliminate the overlap

Answer

Add a physical barrier between the equipment to separate their use zones

Answer

Increase the fall-zone surfacing depth to compensate for the overlap

Answer

Post a warning sign notifying caregivers of the overlapping zones

Question 7

What is the minimum side use zone (lateral clearance) required for a single-axis swing measured from directly under the pivot point?

Accepted Answer

4 feet

Answer

3 feet

Answer

6 feet

Answer

8 feet