CPSI Audit, Inspection, and Maintenance 5

Question 1

A CPSI is inspecting a slide and finds the exit region has a slope greater than recommended. What hazard does this create?

Accepted Answer

Risk of the child leaving the slide with excessive speed or improper posture

Answer

Increased entrapment risk at the slide exit

Answer

UV degradation of the slide surface

Answer

Increased structural load on the slide support

Question 2

Which type of inspection report is typically shared with a governing body or school board to support budget requests for playground upgrades?

Accepted Answer

Comprehensive annual inspection report

Answer

Daily operational checklist

Answer

Post-incident inspection summary

Answer

Vendor warranty claim form

Question 3

What does ASTM F1292 specifically address in the context of playground safety inspections?

Accepted Answer

Impact attenuation of surfacing materials

Answer

Age-appropriate design guidelines for equipment

Answer

Structural load requirements for platforms

Answer

Visibility and supervision sightlines

Question 4

A CPSI inspects a playground after a heavy rainstorm. What surfacing-specific hazard should be prioritized?

Accepted Answer

Displacement and migration of loose-fill material, reducing depth in critical areas

Answer

UV damage to rubber tiles from sunlight reflection off standing water

Answer

Increased slipperiness of poured-in-place rubber surfaces only

Answer

Erosion of concrete footings below frost line

Question 5

When a CPSI finds a piece of equipment that no longer meets current ASTM F1487 standards but was compliant at the time of installation, what term applies to this situation?

Accepted Answer

Grandfathered non-conformance

Answer

Variance compliance

Answer

Retroactive deficiency

Answer

Code sunset exemption

Question 6

A maintenance technician asks a CPSI whether it is acceptable to use untreated pine lumber for a replacement component on a playground structure. What should the CPSI advise?

Accepted Answer

Untreated pine lacks weather and rot resistance and is not suitable for outdoor playground use

Answer

Untreated pine is acceptable for components more than 24 inches above grade

Answer

Untreated pine is acceptable if sealed with latex paint annually

Answer

Untreated pine is only restricted for use in surfacing, not structural components

Question 7

During an audit, a CPSI reviews the playground's maintenance log and finds a 14-month gap with no recorded inspections. What is the primary concern this raises?

Accepted Answer

Hazards may have gone undetected and uncorrected during that period, increasing liability

Answer

The log format does not meet ASTM recordkeeping requirements

Answer

The equipment warranty may have been voided by lack of documentation

Answer

Insurance premiums will automatically increase due to the documentation gap