Practice Test Geeks(CPI) Certified Professional Installer Practice Test
← All CPI Flashcard Decks

Safety Standards & Regulations Flashcards

7 cards from real CPI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Standards & Regulations flashcards as text

  1. Which ANSI/ISEA standard specifies requirements for high-visibility safety apparel (HVSA) worn by workers near traffic?

    Answer: ANSI/ISEA 107

    ANSI/ISEA 107 establishes performance requirements for high-visibility safety apparel and headwear.

  2. A CPI installer discovers that a conduit run will pass through a fire-rated wall. What is required at the penetration point?

    Answer: A listed firestop system that maintains the wall's fire rating

    NEC and building codes require a listed firestop system to restore the fire-resistance rating of any penetrated fire-rated assembly.

  3. According to OSHA, which personal protective equipment (PPE) is required when working with materials that produce dust above the permissible exposure limit (PEL)?

    Answer: A filtering facepiece respirator rated at minimum N95

    An N95 or higher NIOSH-approved respirator is required when airborne dust concentrations exceed OSHA's PEL.

  4. What is the purpose of a 'toolbox talk' in a CPI work environment?

    Answer: To conduct a brief safety meeting focused on daily hazards

    A toolbox talk is a short, informal safety meeting held on the job site to discuss specific hazards relevant to that day's work.

  5. When using a powder-actuated tool (PAT) to fasten materials, which safety requirement applies?

    Answer: Operators must be trained and the tool must not be loaded until ready to use

    OSHA requires PAT operators to be trained/certified, and tools must remain unloaded until immediately before use to prevent accidental discharge.

  6. Under NFPA 70E, what arc flash boundary must workers maintain unless wearing appropriate arc-rated PPE?

    Answer: Arc flash boundary

    The arc flash boundary is the distance at which a worker could receive a second-degree burn from an arc flash incident without arc-rated PPE.

  7. A CPI technician needs to work from a portable ladder. Which OSHA rule governs the angle at which an extension ladder must be positioned?

    Answer: 4:1 ratio (about 75 degrees)

    OSHA requires extension ladders to be set at a 4:1 ratio (1 foot out for every 4 feet of height), approximately 75 degrees.