Practice Test Geeks(CNC) Computer Numerical Control Machinist Technical Practice Test
← All CNC Flashcard Decks

Blueprint Reading & Technical Drawing Interpretation Flashcards

7 cards from real CNC practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Blueprint Reading & Technical Drawing Interpretation flashcards as text

  1. A drawing callout reads 'CONCENTRICITY ⊚ | 0.002 | A.' What condition is being controlled?

    Answer: The coaxiality of a feature's median points relative to datum axis A

    Concentricity controls the location of a feature's median points (derived axis) to be within a cylindrical tolerance zone centered on the datum axis.

  2. On a multiview drawing, which view is typically chosen as the 'front view'?

    Answer: The view that best describes the part's shape and shows the most features

    The front view is selected to show the most characteristic shape of the part and the greatest number of visible features with minimal hidden lines.

  3. What does 'MMC' (Maximum Material Condition) mean for a shaft with a diameter callout of 1.000 +0.000/-0.010?

    Answer: MMC is 1.000 inches (largest diameter, most material)

    For an external feature (shaft), MMC is the largest allowable size because that condition contains the most material.

  4. A section view labeled 'SECTION A-A' is identified by cutting plane line arrows pointing in which direction?

    Answer: Toward the section view, indicating the direction of sight into the cut

    The arrows on a cutting plane line point in the direction you look when viewing the resulting section, i.e., toward the section view.

  5. What is the function of a 'parts list' (bill of materials) on an assembly drawing?

    Answer: To itemize each component with part number, description, quantity, and material

    The parts list (BOM) on an assembly drawing identifies every component by balloon number, part number, description, quantity, and often material or vendor.

  6. A drawing specifies a flatness tolerance of 0.003 on a surface. This means:

    Answer: All points on the surface must lie between two parallel planes 0.003 inches apart

    Flatness requires all surface points to fall within a tolerance zone bounded by two parallel planes separated by the stated tolerance value.

  7. What does the abbreviation 'TYP' following a dimension on a CNC blueprint mean?

    Answer: The dimension applies to all identical features unless otherwise specified

    'TYP' (Typical) means the dimension or note applies to all features of the same type shown on the drawing, eliminating the need to dimension each one individually.