← All Civil Engineering PE Flashcard Decks

Water and Wastewater Treatment Flashcards

7 cards from real Civil Engineering PE practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Water and Wastewater Treatment flashcards as text
  1. A water treatment plant uses rapid sand filtration. The design filtration rate is 4 gpm/ft². If the filter box is 20 ft × 30 ft, what is the design flow through this single filter?

    Answer: 2,400 gpm

    Flow = rate × area = 4 gpm/ft² × (20 × 30) ft² = 4 × 600 = 2,400 gpm.

  2. Which disinfection byproduct (DBP) is primarily formed when chlorine reacts with natural organic matter (NOM) in drinking water?

    Answer: Trihalomethanes (THMs)

    Trihalomethanes (THMs) such as chloroform are the primary DBPs formed when free chlorine reacts with NOM.

  3. In a conventional activated sludge system, the sludge volume index (SVI) is 120 mL/g and the MLSS is 3,000 mg/L. What is the settled sludge volume after 30 minutes?

    Answer: 360 mL/L

    SVI = (settled volume mL/L × 1,000) / MLSS mg/L, so settled volume = SVI × MLSS / 1,000 = 120 × 3,000 / 1,000 = 360 mL/L.

  4. A clarifier has a surface overflow rate of 800 gpd/ft². If the flow is 1.5 MGD, what is the required surface area?

    Answer: 1,875 ft²

    Area = Q / SOR = 1,500,000 gpd / 800 gpd/ft² = 1,875 ft².

  5. Which of the following best describes the purpose of alkalinity in coagulation during water treatment?

    Answer: It provides bicarbonate/carbonate ions that react with coagulant to form floc

    Alkalinity (bicarbonate/carbonate) reacts with alum or ferric coagulants to form hydroxide floc and release CO₂.

  6. In wastewater treatment, what does a Return Activated Sludge (RAS) ratio of 0.5 mean?

    Answer: 50% of the influent flow is returned from the clarifier

    RAS ratio = RAS flow / influent flow, so 0.5 means the return flow is 50% of the incoming flow.

  7. The CT concept in disinfection represents:

    Answer: Disinfectant concentration times contact time

    CT = disinfectant concentration (mg/L) × contact time (min), used to ensure adequate inactivation of pathogens per the Surface Water Treatment Rule.

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. ncees.org — Passing score, retake policy, score validity, test delivery, eligibility, fees, exam format, score release, test dates · verified Nov 2026