← All Civil Engineering PE Flashcard Decks

Structural Analysis of Trusses Flashcards

7 cards from real Civil Engineering PE practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Structural Analysis of Trusses flashcards as text
  1. A Pratt truss has vertical members under compression and diagonal members under tension when subjected to gravity loads. Which statement correctly describes the force distribution in a Pratt truss?

    Answer: Diagonals are in tension and verticals are in compression

    In a Pratt truss under gravity loading, diagonal members carry tension forces while vertical members carry compression forces.

  2. Using the method of sections, a cut through a truss exposes three unknown member forces. To solve for all three unknowns, you need to apply which set of equilibrium equations?

    Answer: ΣFx = 0, ΣFy = 0, and ΣM = 0 about a strategic point

    Three equilibrium equations (ΣFx=0, ΣFy=0, ΣM=0) are needed to solve for three unknowns when using the method of sections.

  3. A truss panel point has two members meeting at 45° and 90° to the horizontal, with no external load applied. The member at 90° (vertical) carries zero force. What is the force in the 45° member?

    Answer: Zero

    By the zero-force member rule, if two members meet at an unloaded joint and one is collinear with no load, the other carries zero force as well.

  4. For a simply supported Pratt truss with span L and panel width d, how many panels does the truss have if the top chord members are all horizontal and there are 8 vertical members?

    Answer: 8

    A Pratt truss with 8 vertical interior members has 8 panels, since each panel contains one vertical member.

  5. A K-truss has members arranged in a K-pattern. Compared to a Pratt truss of the same span and load, the K-truss is typically used to:

    Answer: Reduce the unsupported length of compression chord members

    The K-truss subdivides the panels so that vertical members have intermediate bracing points, reducing the effective buckling length of compression chords.

  6. In a Warren truss without vertical members, all interior members are diagonals. Under a midspan point load, the diagonal immediately to the left of midspan is in what state?

    Answer: Compression

    In a Warren truss under a midspan load, diagonals on the loaded side carry compression while those on the far side carry tension.

  7. A truss is said to be 'determinate' when m + r = 2j. For a truss with 15 members and 3 reactions, how many joints must it have to be statically determinate?

    Answer: 9

    Using m + r = 2j: 15 + 3 = 18 = 2j, so j = 9 joints.

How this page was made: written with AI tools and published by Nathan Beja, founder of Practice Test Geeks, who is responsible for its content. Exam facts are checked against the official sources listed below. Not reviewed by a subject-matter expert. Editorial policy

Sources & references

Exam facts on this page (fees, format, dates, passing scores) are checked against these official sources; the date is our last check. Editorial policy

  1. ncees.org — Passing score, retake policy, score validity, test delivery, eligibility, fees, exam format, score release, test dates · verified Nov 2026